1084 CHAPTER 49 1954 Guide tively steaming part of a boiler, the heat transfer may be twice as great as would be obtained if the water surrounding the coil were circulating slowly.

f' " 136 CHAPTER 7 1955 Gtiide'|| circulation of dust and lint.

252 CHAPTER 12 1955 G: average wind velocity from December through February is 15 mph'or.i higher in only 7 of the cities listed and Column 9 shows that a wind velocity& of 15 mph did not occur in any city listed for temperatures equal to or i lower than those shown in Column 8 for the years 1935-1939.

522 CHAPTER 21 1955 Guide giving a perfect swing joint when connected to the vertical riser or radia tor connection, whereas the preferred connection does not give this swing without distorting the angle of the pipe.

870 CHAPTER 37 1955 Guide V operation upon a difference in pressure between the inside of the cylinder and the. suction or discharge line.

CHAPTER 12 1956 Guide 272 Notes fob Table 8. * The inside-outside temperature difference is 70-- (--10) or 80 F except where otherwise noted. * Volume of infiltration, cfh = (no. air changes) x (fioor'or ceiling area) x (ceiling height). 4 The heat losses are calculated by estimating the attic temperature and then calculating the loss thro6uFgrhomtheEqcuematniognu5sain. g the proper temperature difference.

294 CHAPTER 13 1956 Guide Table 10 Total Equivalent Temperature Differentials for Calculating Heat Gain Through Sunlit and Shaded Walls- _______ Son Time Nobth Latitude Wail Facing P.M.

730 CHAPTER 31 1956 Guide A.S.H.V.E.

788 CHAPTER 34 1956 Guide cleaner differs with the size and nature of the dust on which the cleaner operates.

THE DENISON HERALD Denison, Texas, Sunday Moming/Decemb hns-Manville Promotes A ?

970 CHAPTER 42 1956 Guide plaster is drying out, the range and rate of temperature changes (either increase or decrease), should be kept low.

PLAINTIFFS JMMC-261' Standardized Mechanical Joint Cast Iron Pipe and Fittings (Revised, 1950) UNITED STATES PIPE & FOUNDRY CO.

14 CHAPTER 2 1957 Guide Thermal conductance per unit area, Unit conductance: heat transferred per (unit time) (unit area) (degree).................................................................. ...

120 CHAPTER 6 1957 Guide 20 lb packs under a wide range of environmental conditions which were rated as relatively easy, difficult, and impossible, on the basis of the physiological reactions of the subjects at the end of the 4-hr period as shown in Table 3 and Fig. 3.

282 CHAPTER 12 1957 Guide Electric Motors and Machinery Motors and the machinery which they drive, if both are located in the room, convert all of the electrical energy supplied into heat.