American Society of Heating and Ventilating Engineers Guide, 1934 admitting and shaking grates.

1934American Society of Heating and Ventilating Engineers Guide, or contactors, which should break all of the power lines.

American Soceity of Heating and Ventilating Engineers Guide, 1934 .

ofAmerican Society Heating and Ventilating Engineers GmDiTlgjjl | ----^--------- Chapter 8--Cooling Load 1 SUN 1 Si and thickness of the glass and the angle between the rays of the character ,gs The temperature of the glass is raised by the sunlight ana ^.g jieat ;s then delivered to the air on the two sides Of absorbed nea nrooort;on to the difference between glass and air temthe glass in p f Oh_i < a-" c 91 0 i ..

American Society of Heating and Ventilating Engineers Guide, 1935 Chapter 28 Automatic Fuel Burning Equipment admitting and shaking grates.

American Society of Heating and Ventilating Engineers Guide, 1935~ boiler and the horizontal main or runout is compensated for by the use of reducing ells (Figs. 5 and 6).

American Society of Heating and Ventilating Engineers Guide, 1935 HEATERS, Indirect HEATING SYSTEMS.

INDEX THE A.

American Society of Heating and Ventilating Engineers Guide, 1936 supplied through or near the ceiling.

w American Society of Heating and Ventilating Engineers Guide, 1936 If the radiator is connected as shown in Fig. 11, with the heater connected to provide freedom of expansion, the heating circuit may be assumed to consist of a heater, 25 ft of pipe, 8 elbows, 1 radiator valve, and 1 radiator.

American Society of Heating and Ventilating Engineers Guide, 1936 In order to determine the amount of radiating surface necessary to maintain the MRT at 72 F, assume the surface, temperature of the hot plates to be installed to be 200 F, which is approximately the temperature they would have -if heated by steam.

American Society of Heating and Ventilating Engineers Guide, 1936 Head................. ................................................................................................................................

American Society of Heating and Ventilating Engineers Guide, 1937 measurements are given in actual intensity or energy units, they can be converted to decibels by this relation.

American Society of Heating and Ventilating Engineers Guide, 1937 PROPORTIONING WALL STACKS The wall stack for an upper floor should be made not less than 70 per cent of the area of the leader.

American Society of Heating and Ventilating Engineers Guide, 1937 Should the steam pressure be dropped to J^-lb gage, the pressure on each side of the orifice would be balanced and no steam flow would take place.