Document zoY1L43GgpvNXKDYrxy0rdGoa

Page 14 DOUBLE END SOCKET fi Tail Light Brake Ground Stop Light Double End Socket lor making cable extensions, avoiding the necessity ol long cables or reels. Fig. 21 12 VOLT RESISTOR WIRING DIAGRAM Electric Brakes are designed to operate from a 6 Volt System. Where a 12 Volt System is used this resistor reduces the current to the required amperage. ' Hand Coniroller Ho. \ | '*? * Hand and Foot Controllers can be supplied with integral stop light switch. VOLT RESISTOR No. 284 3-A for 2 No. 2843-B for 6 - ` -2 AT,1.' {..(. ' c'M * 12 Volt Battery Starter Switch Control or 4 Brakes No. 3363-A lor 6 Brakes No. 3363-C for Axle Loads Less than 2000 Lbs. Fig. 22 SERVICING BAKELITE COUPLING PLUG 3 Wire Cable Assembly (SeeFig. 23) Remove outer cover of cable (1) 1)4" back from end exposing rubber covered wires (2). Remove insulation from wires (2) 3/16" back from end. Slide cable (1) through plug handle (10). Place dust shield (12) on cable (1). Assemble cable clamp (3) as close to the end of cable as possible. Slip all wires' (2) through'insulating washer (4). Slide insulating sleeves (5) on wires (2). Solder ter minals (6) on wires (2) and slide insulating sleeves (5) down over soldered ends of terminals (6). Place terminals (6) on bolts (7) in plug end (8) through terminal clip (13). Refer to Figure 2,3 for wire color code and markings on plug end (8). CONNECTIONS MUST BE ACCURATE. Tighten nuts (9) down on terminals (6). Bend terminals (6) up at a 90 angle after tightening nuts (9). If this is not done plug handle (10) will not slide down over wires. Slide plug handle (10) down to plug end (8). Turn plug handle (10) so bolt in cable clamp (3) will not rest on top of either of the two lugs inside of plug handle (10). Be sure the key on plug handle matches with key on plug end. Assemble bolts (11) through plug handle (TO) and plug end (8) to hold them to gether. SERVICING' BAKELITE COUPLING PLUG 4 Wire Cable Assembly(SeeFig. 241