Document zQEjKgBO6MD2nJk3pMMxRbepR

MATERIAL SAFETY DA~T A SHEET McLUBE 1775 IDENTIFICATION Manufacturer's Name Address: McGee Industries, Inc. 9 Crozerville Road Aston, PA 19014 Chemical Name 6 Synonyms: Fluorocarbon Polymer/ Organic Resin Binder HAZARDOUS INGREDIENTS Materials: Emergency Telephone No: (215) 459-1890 Trade Name E Synonyms: McLube 1775 a CAS No. Bv Wt. TLV 2-Butanone 78-93-3 40 200 ppm Toluene 108-88-3 38 100 ppm 1,1,2-Trichloro-l.2.2-trifluoroethane 76-13-1 10 1000 ppm PHYSICAL DATA Boiling Pt., 760 mm.Hg (F|: iis - 231 Melting Point: N/A Specific Gravity: o.9 Vapor Pressure (mm.Hg. 20C): 70 Vapor Density (Air=l); 2-5 Solubility in Water (% by Wt.): Nil % Volatiles by Weight: 91 Evaporation Rate (Ether-1); Appearance and Odor: Yellowish, translucent liquid, slight ethereal odor. 5%Slow FIRE AND EXPLOSION DATA Flash Point (Test Method): 16F (TOC), 30F (TCC) Flammable Limits (Wt. % 77F): L.-^er 1.0 Extinguising Media: C02, dry chemical, freon. 10 Special Fire Fighting Procedures: Unusal Fire "and Explosion Hazard: Keep containers tightly closed. REACTIVITY DATA an<* Pen '--------------------------------------- ' Stability: Stable. Full protective equipment including self-contained breathing apparatus should be used. Isolate from heat, electrical equipment, sparks Closed containers may explode when exposed to extreme heat. Incompatibility: Oxidizing materials. Hazardous Decomposition Products: Carbon monoxide, carbon dioxide, possibly small quantities phosgene, hydrogen fluoride and organic fluorides. Polymerization: Will not occur. 086561 CONFIOFNITAL HEALTH HAZARD INFORMATION Exposure Limit: tlv 100 ppm. Routes of Exposure and Effects Inhalation: 200 ppm for prolonged periods may cause headache, dizziness, loss of balance. Higher levels can lead to unconsciousness or even death. Skin Contact:1 Irritation; prolonged contact may cause dermatitis. Eye Contact: Irritation. Ingestion: Harmful if swallowed. Carcinogenicity: None of the components in the product is listed by IARC, NTP or OSHA as a carcinogen. EMERGENCY AND FIRST AID PROCEDURES Eyes: Flush thoroughly with large amounts of water for at least 15 minutes. Skin: Wash thoroughly with soap and water. Inhalation: Remove to fresh air. If not breathing, have qualified person give mouth-to-mouth resuscitation. If breathing difficult, give oxygen. Call a physician. Ingestion: Do not induce vomiting. Call a physician. PROTECTION INFORMATION Ventilation: Control vapor to standard. OSHA standard 100 ppm. Personal Protective Equipment- Respiratory: In absence of environmental control, approved organic-type respirator required. For emergencies, positive-pressure breathing apparatus or full-face respirator with approved organic vapor canister recommended. Lye: Safety glasses; eye-wash station should be available. Gloves: For frequent or prolonged contact, use non-absorbent gloves. Other: Boots and apron may be necessary depending on extent and DISPOSAL PROCEDURES severity of exposure. Spill or Leak: Remove all sources of ignition: flames, hot surfaces, and electrical, static or frictional sparks. Avoid breathing vapor. Ventilate area.t Soak up with inert absorbent such as sand, earth or vermiculite and Waste Disposal: Dispose in accordance with Put in closed container for with local, state and federal regulations. prompt disposal. PRECAUTIONARY STATEMENTS AND ADDITIONAL INFORMATION Contents may be under pressure; open slowly to release internal pressure. Store containers out of sun, away from heat, sparks or flame. Use with adequate ventilation; avoid breathing vapor. Avoid contact with eyes and prolonged contact with skin. Heating solid active ingredient above 500F may cause formation of potentially toxic substances. Do not smoke while using nor contaminate tobacco products. Wash hands thoroughly after handling. Do not reuse empty containers; do not burn or use cutting torch on empty containers. January, 1987 DO 08656? CONFI DENT T Al.