Document zMbqvVoLE1N8KOzDGq933y77

Radiators UTICH HHDIflTDH CDHPDHHTIQH Utich. N.Y THE UTICA CAST-IRON CONVECTOR The Utica Convector is designed for installation within enclosures and to heat effectively by convection. The cored section is ample to assure good circulation and rapid air elimination. The widely spaced fins, integrally cast, will not clog and offer minimum resistance to air flow. Utica Convectors will perform equally well on steam, vapor, vacuum and hot water systems. They are simple in construction, durable and efficient. The Utica Convector Made in 3% in., 5^ in., 7% in., and 9% in. widths and in any length above 18 in. in multiples of 5 in. UTICA REDSQUARE BOILERS are stream line in ap pearance and scien tifically designed for efficiency and fuel economy. The 17 Series will carry from 200 to 740 sq ft steam radiation and 330 to 1230 sq ft of water radiation. The 25 Series will carry from 620 to 1240 sq ft of steam radiation and 990 to 1990 sq ft of water radiation. Also available in oil burning types with ex tended jacket. 17 Series Redsquare Boiler 5 Series Redsquare Boiler. Humid-Heet Radiator The HUMID-HEET Radiator furnishes the required amount of radiator heat--and replenishes the air with moisture. Made in a wide range of sizes. Midget Radiators Cut-away vieiv of Bumid-IIeel Radiator showing porcelain enameled, water wells Midget Radiators--Due to their narrow width (2-tube, 3]/i in., 3tube, 4.% in.) and sections 1)4 in. center to center, occupy one-third less space than standard tube radiators. .8-Tube Midget m in. wide Also Manufacturers of Standard Tube and Wall Radiators 1000 Registers and Grilles The Auer Register Co. 3608 Payne Avenue, Cleveland, Ohio Manufacturers of Registers and Grilles for Gravity and Air Conditioning Systems; Wrought Metal Grilles for Concealing and Protecting Radiation AIR CONDITIONING REGISTERS AND GRILLES Auer Registers and Grilles for Air Conditioning have been designed to meet all modem requirements--appearance, practicability, and simplicity in installation and operation. They are made in various designs to harmonize with modern interiors. Constructed and tested to operate with high efficiency in any system of forced air, they are a departure, not merely an adaptation, from gravity registers. They are designed for easy installation in either new construction or remodelling. No. 2030 Sidewall The design shown is our standard design, termed Classic. It is very adap table to most interiors; other designs, however, can be furnished. This type is made with a band frame and is installed after plastering. It is ideal for new construction or remodelling. Without a valve it is used as a return. No. 2230C Sidewall This illustration shows register directing air in three directions. J//7//l l\\\\\L It can be made to direct air in one direction only or in two directions. The directing air blades can be set at any angle specified. Installation can be made with band frame or sliding frame as shown in previous illustrations. No. 2010 Sidewall This type is used in new construction exclusively. The sliding frame is anchored to studdings before plastering. After plastering, the register is easily attached to the frame and can be slid to the position desired between the studs. The same type furnished without a valve is used as a return. No. 2005 Oblong Auer Registers and Grilles can be fur nished in many designs. Auer Registers and Grilles can be furnished in any standard finish. Illustrated catalogue showing complete line of registers for all purposes and chart of open areas and capacities will be forwarded on request. 1001