Document x1zzbn71Zg45NYQwKgJo6wnnm

Of & po u t wfeAA&ii J*<liWirfUW * ; DATA SHEET TI-PURE* R-943 A- 73Z97-2, RUTILE TITANIUM DIOXIDE SLURRY Ti-Pure R-943 is an aqueous slurry of Ti-Pure R-933 with the following general properties: ^ TYPICAL ANALYSIS3 (Ti-Pure R-933) Titanium Dioxide (HO2) . 7m min. Aluminum Oxide (AfeOs) 8% max. Silicon Dioxide (Si02) 9% max. ,j*. *"*&*"% AS7>V >?7< T'-rf&Xt 'c a l p h y s ic a l p r o p e r t ie s 3 (Ti-Pure R-933) Specific gravity 3.6 Bulking value 0.033 gal/lb (0.275 L/kg) Oil absorption (ave.) 36 lb/100 lb (360 g/kg) pH % Volatiles @ 221 F (iosC) (Determined at time of packaging) 8.0-9.5 0.5% max. TYPICAL PHYSICAL PROPERTIES* (Ti-Pure R-943)--Slurry Basis Solids (2 hrs. at 221F/105C to /I 230F/110C) Dispersant 62.0 0.5% 0.7% max. Biocide (non-mercurial) 0.06% Slurry density 1 $.3 0.3 Ib/gal (1.83 + 0.04 kg/L) Lbs pigment/gal R-943 9.5 0.3 (1.14 0.04 kg/L) pH 7.0-9.0 Reg. US. .Pat. 8 T.M. Off., Du Pont Co. Brookfield viscosity--less than 500 cps (mPa-s) (#3 spindle @100 rpm) Hercules rheology--less than 5.0 cm deflection @ 2000 sec.-1 325 mesh residue--less than 0.02% (Brushed) The above tables give typicalproperties based on historical production perfor mance, Du Pont does not make any express or implied warranty that this productwill continue to have these typical properties. USES Ti-Pure R-943 has properties similar to Ti-Pure R-941. It was formulated for fiat paints needing blue undertone pigments. PERSONAL SAFETY Health Hazards In DuPont tests, dusts of titanium dioxide, including titanium dioxide treated with amorphous silica, pro duced a response in the lungs of rats comparable to the effects given by inert or nuisance dusts. When a titanium dioxide slurry is allowed to dry, any resulting dust is regulated as an air contaminant by the Department of Labor (OSHA) under Title 29 CFR 1910.1000. OSHA has ruled that an employee's expo sure to titanium dioxide in any eight-hour work shift of a forty-hour week shall not exceed a Time-Weighted Av erage of 15 mg/m3 in air.b The American Conference of Governmental Industrial Hygienists (ACGIH) classifies titanium dioxide as a nui sance dust and recommends a Threshold Limit Value, TLV, of 10 mg/m3 total dust or 5 mg/m3 respirable dust. The information net forth herein Is furnished froeof charge end is based on teehniesi dote that Du Pont believes to be reliable It ie intended foruse by persons having technical skill and at their own discretion and risk. Since conditions of use are outside our control, we make no warranties, express or Implied, and assume no liability In connection with any use of this infdrmation. Nothing herein Is to be taken as a license to operate under or a recommendation to infringe any patents, _____________ OSHA does not define a specific limit for a titanium dioxide modified with amorphous silica. If Ti-Pure R-943 is considered as a nuisance dust when dried,: down, the OSHA limit is 15 mg/m3 total dust, 5 mg/m3 respirable dust. Du Pont has elected to observe the ACGIH limit in handling Ti-Pure R-943. Safety Precautions For dust concentrations above the minimum, workers should wear dust respirators, such as Mine Safety Appliance No. 66 CM-73053 type filter. PACKAGES Ti-Pure R-943 Rutile Titanium Dioxide Slurry is avail able in rail cars of approximately 50 tons (45 metric tons) (dry basis). Tank trucks of approximately 15 tons (13.5 metric tons) are available within an approximate 200 mile radius of shipping point. Current shipping points are New Johnsonville, TN; Antioch, CAand Newark, NJ. This product is not regulated as a hazardous material by the Department of Transportation.b bDue to changing recommendations and governmental regulations, such as those of the Department of Labor, U.S. Environmental Protection Agency, and the Pood and Drug Administration, references herein to governmental re quirements may be superseded. You should consult and follow the cuirent governmental regulations, such as Hazard Classification, Labeling, FoodUse Clearances, Worker Exposure Limitations, and Waste Disposal Procedures tor the up-tchdate requirements. E. I. du Pont de Nemours & Co. (Inc.) * Wilmington, Delaware 19898 CHARLOTTE NC 28230 6250 Falrview Rd., P.0. Box 30517 704-364-1550 CHICAGO IL 6063}. O'Hare Plaza,jSdite '60 5725 E 312-9 U.S. Sales Offices CLEVELAND OH 44124 5001 Maffleld Fid. 21&SB2-5800 HOUSTON TX 77066 Suite 1620, Post Oak Tower 713-877-5500 NEW YORKNYIOOOI Fm 1129, Empire State Bldg. 350 Fifth Ave. 212-971-4000 PHILADELPHIA PA (Suburban) 308 E. Lancaster Ave. Wynnewood PA 19096 215-896-2000 SAN FRANCISCO CA 94111 Slate 3110 50 California Street 415-391-7300 international Sales Offices IN CANADA Du Pont Canada Inc. Pox660 Montreal S. P.Q. H3C 2V1 514-861-3861 DuPont Canada Inc. P.O.Box 2300 Streelsvllle Postal Station Mississauga, Ontario L5M2J4 416-821-5594 IN EUROPE Du Pont de Nemours International S.A. P.O. Box CH-1211 Geneva 24, Switzerland 022-278111 . IN THE FAR EAST Du Pont FarEast Inc. Kowa Building No. 2 11 -39 Akasaka 1-chome Minato-ku Tokyo 107, Japan 585-5511 0:1 Z r 0/0 Printed in USA DUP050070513 DU POIIT p' W* ~U DATA SHEET TI-PURE* R-943 RUTILE TITANIUM DIOXIDE SLURRY Ti-Pure R-943 is an aqueous slurry of Ti-Pure R-933 with the following general properties: TYPICAL ANALYSIS" (Tl-Pure R-933) Titanium Dioxide (TiC>2) Aluminum Oxide (Alz03) Silicon Dioxide (Si02) Contains TiOj meeting ASTM D476 Type III SpacMeaBont 80% min. 8% max. 9% max. TYPICAL PHYSICAL PROPERTIES" (TLPure R-933) Specific gravity 3.8 fluking value 0.033 gal/lb (0.275 L/kg) ON absorption (ave.) 36 lb/100 lb (360 g/kg) pH 8.0-9.5 % Volatiles @221F(105C) (Determined at time of packaging) 0.5% max. TYPICAL PHYSICAL PROPERTIES* (Tl-Pure R-943)--Slurry Basis SoNds (2 hrs. at 221 F/105C to 230"F/110*C) 62.0 0.5% Dispersant 0.7% i Biocide (non-mercurial) Slurry density lbs pigment/gat R-943 0.00% 15.3 0.3 Ib/gal (1.83 0.04 kg/L) 9.5 0.3 (1.14 0.04 kg/L) pH 7.0-9.0 fU. U.IW.I T.M. OH., Ou Pom Co. Brookfield viscosity--less than 500 cps (mPa-s) (#3 spindle @ 100 rpm) Hercules rheology--less than 5.0 cm deflection @ 2000 sec.-1 325 mesh residue--less than 0.02% (Brushed) The above tables give typical properties based on historical production perfor mance. DuPont does not make any expreas or implied warranty that this product vM continue to have theee typical properties. USES Ti-Pure R-943 has properties similar to Tl-Pure* R-941. It was formulated for flat paints needing blue undertone pigments. PERSONAL SAFETY Health Hazards In Du Pont tests, dusts of titanium dioxide, including titanium dioxide treated with amorphous silica, pro duced a response in the lungs of rats comparable to the effects given by inert or nuisance dusts. When a titanium dioxide slurry is allowed to dry, any resulting dust is regulated as an air contaminant by the Department of Labor (OSHA) under Title 29 CFR 1910.1000. OSHA has ruled that an employee's expo sure to titanium dioxide in any eight-hour work shift of a forty-hour week shall not exceed a Time-Weighted Av erage of 15 mg/m3 in air.b The American Conference of Governmental Industrial Hygienists (ACGIH) classifies titanium dioxide as a nui sance dust and recommends a Threshold Limit Value, TLV, of 10 mf^m*total dustor 5mg/m3 reapirable dust. >-------------------------- ` " Fa You# A/&Z peA 7frts P/4STG up The information set forth herein is furnished free of charge end is based on technical date diet Du Pont believes to be reliable. If ia intended for use by persons having technical skill and at their own discretion and risk. Since conditions of use are outside our control, we make no warranties, express or implied, and assume no liability In connection with any use of this information. Nothing herein is to be taken as a license to operate under or a recommendation to infringe any patents. _______________________________ __________ DUP050070514 N42094.01 OSHA does not define a specific limit for a titanium dioxide modified with amorphous 6iliea. if Ti-Pure R-943 is considered as a nuisance dust when dried down, the OSHA limit is 15 mg/m3 total dust, 5 mg/m3 respirable dust. Du Pont has elected to observe the ACGIH limit in handling Ti-Pure R-943. Safety Precautions For dust concentrations above the minimum, workers should wear dust respirators, such as Mine Safety Appliance No. 66 CM-73053 type filter. PACKAGES Ti-Pure R-943 Rutile Titanium Dioxide Slurry Is avail able in rail carsof approximately 50 tons (45 metrictons) (dry basis), tank trucks of approximately 15 tons (13.5 metric tons) are available within an approximate 200 mile radius of shipping point. Current shipping points are New Johnsonville, TN; Antioch, CA and Newark, NJ. This product is not regulated as a hazardous material by the Department of Transpprtation.b bDue to changing recommendations end governmental regulations, such as thpse.ofthe Department of Labor, U.S. Environmental Protection Agency, and the Food and Drug Administration, references herein to governmental re quirements may.be superseded. You should consult and follow the current governmental regulations, such as Hazard Classification, Labeling, Food Use Clearances. Worker Exposure Limitations, and Waste Disposal Procedures for theup-tordate requirements. E. I. du Pont de Nemours & Co. (Inc.) Wilmington, Delaware 19898 CHARLOTTE NC 28230 6250Falrvlew Rd.. P.O. Box 30517 704-364-1550 U.S. Sales Offices CLEVELAND OH 44124 5001 Mayfield Rd. 216-382-5800 CHICAGO IL 60631 O'Hare Plaza. Suite 760 5725 E-River Rd. 312-982-4300 HOUSTON TX 77056 Suite 1620, Rost Oak To1 713-877-5500 NEW YORfrUY 10001 Rm t129ftmpire State Bldg. 350 Fifth Ave. 212-971-4000 SAN FRANCISCO CA 941 Suite 3110 50 California Street 415-391-7300 International Sales Offices IN CANADA Du Pont Canada Inc. Box 660 Montreal S.P.Q.H3C2V1 514-861-3861 -l-^Du Pont Canada Inc. >0^00x2300 Streetsvilte Postal Station Mississauga^ Ontario L5M2J4 416-821-5594 IN EUROPE Du Pont de Nemours International S.A. P.O. Box CH-1211 Geneva 24, Switzerland 022-278111 IN THE FAR EAST Du Pont Far East Inc. Kowa Building No. 2 11-39 Akasaka 1 -chome Minato-ku Tokyo 107, Japan 585-5511 *tusmearm e* Printed in U.S.A. DUP050070515