Document vqwRjEqak5gw8zY9YZ69q4yq

Machining the Opposite Side Machining tha Opposite Side 13 D Loosen the trolley handle and rotate the machine into the upside- down position. 2) The procedure for cutring in the upside-down position is the same, though fewer steps are needed since all settings have already been made The lathe mounts in the same manner. WARNING: Advancing the cut ting heat) towards the hat of the rotor requires even more care vdien upside down. Becareful not to bump the hat of the rotorl Often.the shut-off switch will still be depressed from the pre vious cut,so the machine will not tuni on until you move the cutting head.The cutting arms will also still be advanced in from the last cut,so be sure to loosen the clamp knob and spread the arms before feeding the head towards the center of the rotor. Measuring and adjusting for runout is exacdy the same as in the upright position. The entire cutting process is also the same, right down to the silencer clip which mounts upside down in the exact same position. After loosening the trolley handle the lathe can be flipped over to machine the opposite side of the vehicle PHO-CHTx BOO-SA3-DO! O Produced by Ford Motor Company MOTO 000067