Document qkrExmMg32Qnnq39Z7poVBxbx
U.S. DEPARTMENT OF LABOR Occupational Safety and Health Administration
MATERIAL SAFETY DATA SHEET
,t; 'i
Form Approved OMB No.^ 44-R1367
Required under USDL Safety and Health Regulations for Ship Repairing,
Shipbuilding, and Shipbreaking (29 CFR 1915, 1916, 1917)
January. 1979
SECTION 1
MANUFACTURER'S NAME
EMERGENCY TELEPHONE NO.
PPG INDUSTRIES, INC.
(304) 843-1300
ADDRESS /Number, Street, City, State, and ZIP Code]
One Gateway Center, Pittsburgh, PA 15222
CHEMICAL NAME AND SYNONYMS
Hydrated Amorphous .Silicon Dioxide
--hMi4al family
Non-Metallic Oxide
trade name and svnonvms
Hi-Sil 260 hvdrated amorphous
FORMULA
S102
allies
SECTION II - HAZARDOUS INGREDIENTS
PAINTS, PRESERVATIVES. & SOLVENTS PIGMENTS
% tlv (Units)
ALLOYS AND METALLIC COATINGS
BASE METAL
catalyst
alloys
vehicle solvents additives
metallic coatings
; FILLER METAL PLUS COATING OR CORE FLUX
\ OTHERS
OTHERS
HAZARDOUS MIXTURES OF OTHER LIQUIDS, SOLIDS. OR GASES
TLV K (Units)
TLV % (Units)
BOILING POINT (F.) VAPOR PRESSURE (mm Hg.) VAPOR DENSITY (AlR-1) SOLUBILITY IN WATER APPEARANCE AND ODOR
SECTION III - PHYSICAL DATA
4046 None N/A
SPECIFIC GRAVITY (HjO-1)
PERCENT. VOLATILE BV VOLUME (%) EVAPORATION RATE ( .... -1)
Insoluble White, odorless powder
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
flash point (Method UM4)
None
flammable limits
Extinguishing media
N/A
special fire fighting procedures
N/A
li
unusual fire and explosion hazards
None
2.00 None N/A
PAGE (1)
(Continued on reverse side)
Form OSHA-20
Rn. Miy 71
St- 07
SECTION V - HEALTH HAZARD DATA
THRESHOLD LIMIT VALUE
20 million particles per cubic foot (OSHA 29 CFR 1910.1000)
EFFECTS OF OVEREXPOSURE
Drying of skin and mucous membranes of nose and throat; drying action due to
absorption of moisture and oils. Can cause irritation and occasional nosebleeds.
emergency and first aid procedures
See attached sheet
SECTION VI - REACTIVITY DATA
STASILITY
UNSTABLE
conditions to avoid Avoid high-temperature,. (calcining) may be converted to crystalline
STABLE incompatasiuty (Matthau to
forms of silica See attached sheet
HAZARDOUS DECOMPOSITION PRODUCTS
None
HAZARDOUS POLYMERIZATION
MAY OCCUR WILL NOT OCCUR
CONDITIONS TO AVOID
None
SECTION VII - SPILL OR LEAK PROCEDURES
STEFS TO K TAKEN IN CASE MATERIAL IS,RELEASED OR SPILLED
, ,,
,
vacuum spilleo material ana place in closed plastic bags for disposal;
then thoroughly flush area of spill with water.
WASTE DISPOSAL MIECTTHOOD
Bury in sanitary landfill or contact local waste disposal contractor. NEVER FLUSH SPILLED MATERIAL TO SEWER.
SECTION VIII - SPECIAL PROTECTION INFORMATION
respiratory protection (Specify type)
NIOSH/MSHA-aDDroved mechanical filter tvoe. for expo sure above TLV
VENTILATION
local exhaust Sufficient to maintain emolovee exDOSure below TLV
special
mechanical (Genml)
OTHER
protective gloves Cotton or rubber with
EYE PROTECTION
tight fitting wristlets^
other protective equipment
Protective c.lo.th.ing to prevent s,k,in contact
SECTION IX SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
See attached sheet
other precautions
See attached sheet
PAGE (2)
Zfc is.5*0
Form OSHA-20
R*. May 72
SL 074519
MATERIAL SAFETY DATA SHEET ON HI-SIL 260 HYDRATED AMORPHOUS SILICA (JANUARY, 1979)
SECTION V - HEALTH HAZARD DATA
Emergency and First Aid Procedures
Eye Contact: Immediately flush with plenty of water for at least 15 minutes. If irritation occurs, consult a physician.
Skin Contact: Flush thoroughly with water. If irritation occurs, consuit a physician.
Inhalation: If symptoms of discomfort or irritation occur due to apparent inhalation overexposure to Hi-Sil, remove affected person to fresh air. If irritation or discomfort persists, consult a physician.
SECTION VI - REACTIVITY DATA
Incompatibility (Materials to Avoid)
Avoid alteration of product properties before use. Product surface altera tions caused by calcining or mixing with additives may alter toxicolo gical properties.
SECTION IX - PRECAUTIONS
Precautions to be Taken in Handling and Storing
Wear respiratory protection when exposed to dust and in any event where exposure is above OSHA standard. Respiratory protection must be NIOSH/MSHA-approved mechanical type f ilter.
Store in dry, well-ventilated area.
Other Precautions
A vo id prolonged 0 r rep eated inhalation of dust May irritate re sp ira tory tract.
Avo id prolonged re pea ted or excessive con tac t May cause irr it at ion and discomfort.
Wash tihoroughly a ft e r hand 1 in g.
SL 074520