Document qdYGbynNGDOm0MeVDneaDVyjR

SPLICING MATERIALS 9/78 B IMPACT TOOL The B impact tool is used for terminating conductors on 66-type connecting blocks. The dual-colored handle assists in tool orientation. One half, in yellow plastic, signifies the cutting edge side of the blade; the other half is of black plastic. It also has a double-ended blade with one end for push-on and cutting and the opposite end for push-on. ORDERING INFORMATION (qty) Tool, Impact, B 714Et TOOL The 714B tool has a reversible steel blade attached by a single screw to a molded plastic handle. The tool is used to make all terminations (both loop-through and end) on 66-type connecting blocks. One end of the blade is used to seat and cut conductors; the other to seat the conductor for looping. The yellow portion of the handle identifies the cutting edge. ORDERING INFORMATION " (qty) Tool, 714B 724A TOOL The 724A tool is a 2-pronged fork with an insulating handle. The tool is used to remove wires from the terminals of 66-type connecting blocks without disturbing or degrading the adjacent wire connections. The fork is sized to fit around the beams of the terminal and underneath the seated conductor. End and Loop-Through Terminations Using 7148 Tool ORDERING INFORMATION (qty) Tool, 724A 788-TYPE TOOLS 788-type tools consist of an insertion tool (7S8B1) used to seat cable and cross-connecting wires into the 88-type connecting block -and a cutoff tool (788C1) used to cut cable conductors after they have been seated in the index strips. The handle (788A1) is ordered separately. The 788D3 isa single-pair insertion/eutoff tool. The 7S8H1 isa 5-pair impact insertion tool and the 788JI isa 5-pair impact insertion cutoff tool. 733 Tools ORDB?lNG INFORMATION (qty) Tool, 78SA1 (handle) (qty) Tool, 788B1 (head) (qty) Tool, 7SSC1 (head) (qty) Tool, 78SD3 (qty) Tool, 788H1 (qty) Tool, 7SS-J1 5 l Page 9.32 TAY0000456 ATT-NJ-DEG-0076258