Document pmkke5Q7BaKeJ1jv63LgEE76X

Coffwmil o.tt October. 1073 ; Kayio 10 Asbestos Free Pipe insulation For hot water heating, high temperature hot water, steam condensate piping systems and ail heated lines to 1200 F. } US9S Kayio 10 Asbestos Free* is particularly suitable for use 0n high temperature piping systems wnere high per formance ano extended temperature range are required. K.iylo 10 Asbestos Free is widely used on hot piping where a great degree of physical abuse resistance is re quired. sucn as boiler and eouipments rooms. benefits rugged--Kayio 10 Asbestos Free Pipe Insulation is a strong and rigid material that resists mecnanical damage during shipping, installation and service, it is well suited for riser piping m exposed locations, versatile--Kaylo's extended temperature range offers . brooder use for ail hot piping to 1200F. description Kayio 10 Asbestos Free Pipe Insulation is a rigid white hydrous calcium silicate insulation molded in sections for all types of indoor and outdoor piping that requires an abuse resistant, durable, efficient insulation, for tem peratures up to 1200F. The insulation does not contain any asbestos fibers. . no asbestos--Kayio 10 Asbestos Free can be safely used and applied in conformance with proposed OSHA regu lations. will not causa stress corrosion eraeklng--Kayio 10 As bestos Free will not cause stress corrosion cracking of stainless steel because Kayio 10 Asbestos Free contains an inhibitor and has a very low soJuble chloride content unaffected by moisture--Kayio can be completely sat urated in water without appreciable loss of strength and regains its strength and thermal value after drying out pent finished acoearance. Mitered fittings are finished with insulating cement end covered wrrn canvas. Kayio Klaef Pipe Insulation comtlnes weatherproofing end insulation in one application. Attractive, mtimenance-tree factory-applied lackets of stainless steel and aluminum are como/ere with longitudinal locking seems Performance characteristics thermal conductivity density (apbrox.) modui'js of rupture (ASTW C-446) resistance to abrasion (Conventional tumbling test-loss in weight before heating) (ASTM C-421) corrosion resistance dimensionai stability linear shrinkage after heating for 24 hours in a muffle (ASTM C-356) % length toss 11 lb. pcf. 75 lbs./sq. in. after 10 minutes. 20% max. after 20 minutes. 45% max. does not cause or acceler ate corrosion of steel, alu* minum, or stainless steel 1.4 (at 1200F) specification compliance HH*l-523c Insulation Block, Pipe Covering, Thermal. Calciiim silicate (For temperatures up to 1200F) * \\ (Pipe covering) Classes A thru F. MIL1-.'27810 Insulation Pipe Covering, Thermal. Grade 1. Class B; Grade 2, Class 0; Grade 3, Class , Type 1 and 2. MIL-1 *24244 (Ships)--Insulation Materials, Thermal, with Special Corrosion ana Chloride Requirements, Type 1A. 1C. 10, IE. ASTM C533-67 economic thickness--ambient air at 80F P*as Taos. Tiam. Dm. IPS V* t m m : 2** 3 3V* 4 5 400 tm ia m 6Z9 ET KL ST ET HL rr ET HL ST 1 17 95 m 1 1 19 20 97 95 w IV* l 26 99 2 1 27 98 2 32 98 2 IV* 26 90 2 IV* 33 93 2 iv* 33 91 2V* m 40 94 2V* m 36 93 m IV* 43 95 lYi 40 106 2 47 110 2 50 109 2V* 52 104 2V* 55 104 2V* 61 10< 2V* 64 103 3 79 104 3 72 99 3 83 102 3V* 82 102 3V* 94 105 3V4 63 113 71 117 70 107 81 III 84 112 96 112 94 105 HI 110 115 108 118 106 120 107 137 110 economic thickness table key ET--economic thickness (inches) HL--hast loss (Btu/eff. hr) ST--surface temoerature (F) importance of specifying economic thickness Selection of insulation thicknesses for any specific eoplication should take into consideration at least the following cntens. 1. Cost of insulation aopiied. 2. Cost of heat energy. 3. Cost of eaoitai. 4. Cost of deprecation--plant and insulation. 5. Capital investment in heat production equipment. 6. Temoerature dif ferential. 7. Site of the pipe or surface. 8. Conductivity of insuiacon. ^ for hot piping, the tabulated thicknesses are oobmum thick nesses calculated on an "Economic*** basis for heat conserve* bon under average operebng conditions end assure adeauate temperature control. Special conditions may warrant the use of other thicknesses. -- from "Mow to Dotormmo Economic Thieknaa* of Inauiatwn"-- Notnnai inauiahon Manufacturer* AaaociatMA. aconomrc tfneknsaa--riaaioa Piping to 1200F (80F imOttnt ttiil air) sizes pipe sizes--Kaylo Pipe Insulation is available to fit nominal pipe sizes from t* to 39* in diameter, and nominal copper tubing sizes from *** to 3* in diameter, it is manufactured to Oimen. sionai Standards Sizes to permit nesting in muitipie.kayer applications. thickness--Kaylo Pipe Insulation is available in Single layer thicknesses from 1* to 3* depending upon pipe size. Kaylo Cooper Tubing insulation is available in single layer thicknesses of 1* ana IV**. forms--Kaylo Pipe Insulation is available in sectional or multi- Pipe Tots. Tama. OlfL mm 440 ISO C8 IPS ET HL ST FT HL ST ET KL ST 6 2 46 91 3 98 ICQ 4 140 104 7 2 47 92 3 104 103 4 155 107 8 2 55 91 3 IIS 100 4 169 106 9 2 56 92 3 123 102 4 182 110 10 11 12 2 2 65 73 91 92 3m*4 124 133 98 4 98 4 200 107 205 107 2 81 92 3*4 142 98 4V* 210 105 14 16 2*4 3 72 70 9a0 3V4 4 157 159 99 s 213 103 97 6 207 99 18 3 78 88 5 147 92 6V* 212 97 20 3 IS 88 S 151 93 ft* 229 98 24 3 100 89 5 176 93 6*4 266 99 segmental form depending upon pipe size. All insulation is furmsned in 3 ft. sections. jackets Jackets are faetory.aopiied on Sectional Pipe and Tube Insula tion. On Multisegmentai forms they are furnished but not adhered. canvas--Kaylo Sectional Pipe Insulation indudes standard canvas isckets. at an additional charge, on thicknesses up to end Induding 3* depending on pipe size. 8 ox. canvas racket is available for all types, sizes and thick nesses of Kaylo Pipe end Tube Insulation at an additional charge. smooth and embossed aluminum--Kaylo is also available with smooth or embossed aluminum laeket .016* thick: or stain less steei .010*. These weetheroroof tickets provide greater resistance to mechanical damage and present a neat finished appearance to outdoor pipe lines. The longitudinal seam has a self-locking tome Butt seating strips ere furnished with an integral weatherproof mesne for sealing end joints. ^l:K<OVrcNsi^2bRWING OWENS-CORNING F1BERGLAS CORPORATION Mechanical Products Division Fibergias Tower, Toledo. Ohio 43659 A AA nm a n