Document pm7Y0g6Z58mROB906RBGnQY46

S8F9 89 A3H0 % _ _____ _____ TYPICAL ANALYSIS DATA PLAINTIFF'S EXHIBIT CHV-51I PRODUCT: ... PANELEX T.P. DESCRIPTION: NON-ASBESTOS, ULTRALIGHT, HIGH-STRENGTH, INSULATION- SPECIMEN TYPES: I GUNNED | RECOMMENDED SERVICE LIMIT: 2000F. . ... P.C.E.: CONE 5 (2230F) ASTM CLASS (C-401): CLASS "0" WATER REQUIRED TO CAST 100 LBS MATERIAL: N/A .. MATERIAL REQUIRED TO GUN 1 CU. FT. : * 28 TO 32 LBS RECOMMENDED PRE-WET PER 100 LBS. (GUN) : IQ TO 1.5% CBY WEIGHT! PACKAGING: ... . 50 LB BAG . . ' APPLICATION METHODS: TROWEL, CAST, GUN, PUMP ' CHEMICAL ANALYSIS Si2 ai2o3 Fe23 CaO MgO T102 Alkalies as Na20 L.O.I. 41.83 12.96 2.75 26.86 6.39 .33 3.05 5.83 THERMAL CONDUCTIVITY (BTU/FT2/HR./F/IN.') MEAN TEMP. "K" 500 1000 1300 .80 1.15 1.27 PHYSICAL PROPERTIES: Fired to F 220 500 1000 1500 2000 ' Density Lbs/cu.Ft. 25.4 26.027.1 26.5 25.3 Linear Change % 0.0 -0.2 -0.6 -1.0 -1.7 Modulus of Rupture, psi - 154 150 135 ' 84 45 ' Cold Crushing Strength, psi 294 289 ' 287 186 84 * NOT INCLUDING FIELD WASTE NOTE: ASTM TEST METHODS USED WHERE APPLICABLE 375C4Q6G1 C873 Rev.i INFORMATION GIVEN AND RECOMMENDATIONS MADE HEREIN ARE BASED UPON OUR RESEARCH ARE BELIEVED TO BE ACCURATE. BUT NO GUARANTEE. EITHER EXPRESSED OR IMPLIED. IS MADE L RESPECT THERETO OR WITH RESPECT TO THE INFRINGEMENT OF ANY PATENT. OUR PRODUCTS ni iir-i rv rnMn'iv mo Hi 9Efr9 8a A3H0 THERMAL CONDUCTIVITY - PANELEX TP (Gunned) CONDUCTIVITY FACTOR - (BTU/FT 2/HR/ F/IN) HOT FACE TEMPERATURE MEAN TEMPERATURE ( F) * PERFORMANCE GRAPH - PANELEX TP (Gunned) BTU LOSS (FtVHr) ' COLD FACE TEMPERATURE `THESE CURVES ARE BASED ON STILL AIR, 80 F AMBIENT TEMP AND EM1SSIVITY FACTOR OF 0.9 REFRACTORY A N D CONSTRUCTION ANCHORS