Document o9ErLm71QZRBV18xgQop8r5Er

Ceor^ct Inc- is a wholly owned subsidiary of EMPAX, Inc. PERMIT NO. wnw-157 COMMERCIAL WASTE DISPOSAL. WELL PERMIT to- conduct, underground. / injectionsund.erv provisions, .of. "IR..' 'Chapter' 2.7.'L Texas Water Code- I. Name of-Peraittee: - An - A-` - B. Name--.V `--Geo-Ject;, Incorporated^ " . --V-.-r...' ,.V-cc. 2000 West- Loop South; - _ - - AddressA-L';;'-: '."suite 1800 :~ J Houston, Texas .77027 - II. Type of Permit: Regular XX____________ Amended. III. Nature of Business: ' *?' ; -c -- '* -- / *. Commercial Viaste Disposal Well .r . IV. General Description and Location of Injection Activity .The disposal well, will be used to dispose of industrial wastes from various-sources.......The well will be located on company pro perty approximately 13,200 feet north of the south line-and 1,275 feet west of the east line of the George Ross Survey, Abstract 646, Harris County, Texas. The well is located on property adjacent to the Houston Ship Channel approximately one mile southwest of the San Jacinto Monument. . Injection will be into the Basal Frio Formation in the approximate- subsurface interval from 6,800 feet to 7,500 feet. CONTINUED on Pages 2 through 9. The permittee is authorized to conduct injection rictivity in accordance with. lirr.L tions, requirements and ocher conditions set forth herein. This permit is granto subject to the rules of the Department, other Orders of the Commission and the la of the State of Texas. This permit is valid until amended or revoked by the Commission. APPROVED, ISSUED ANQ EFFECTIVE chis day of October, 1979 SAL OC0015849 WDW-157 ' Page 3 of g 2. - Long String Casing Hole . -v Spontaneous Potential and Resistivity Log - ;Vb.~: Gamma--Ray Log (Full Hole) c. Caliper Log d- Cement Bond Log.after casing is set and cemented-- \- ft T D. The surface casing shall be tested to 1,000 psi fo 30 minutes and the - long string casing shall be tes ed to 1,500 psi for 30 minutes-. . E- After completion of the well, injectivity tests shall be performed to determine the well capacity and reservoir characteristics- Surveys shall be performed to establish preferred injection zones.. Prior to performing injectivity tests, the bottom hole pressure, bottom hole temperature, and static fluid level shall be determined and a sample of for mation water obtained and analyzed- ' VII. Character of the Waste Streams The industrial waste so permitted to be injected shallconsist of the following waste streams: A- Pesticide wastes. B. Caustic wastes. C. Spent metallic wastes, D. Organic wastes. E. Spent acids. F. Waste oils and solvents. VIII, Injection Rates and.Volumes A. The rate of injection, shall not exceed 300 gallons per minute. SAL CC0CI985C