Document kDxN57957XorGK3GYnjp6KDvJ

AIRBORNE FIBER COUNTS for Georgia Pacific Corp. Milford, VA PLAINTIFF'S EXHIBIT August 15, 1974 Samples Collected and Analyzed By: E. J. Kleber Union Carbide Corporation Union Carbide Corporation Mining and Metals Division Niagara Falls, Hew York SGP 0007722 SUMMARY OF FIBER COUNTS Sample No. 1-23 G-3 1-31 H 22 G-10 J-8 J-13 Sample Fibers/cc Time___________________ Description__________________________________ >5^ 5 min. Personal-Dry mix operator (John J. Green) gathering> weighing and adding raw materials to hopper. 30 lbs. SG-210 & 78 lbs. Canadian used per batch. 4.1 41 min. Personal-Same as 1-23. 0.9 21 min. Personal-Same as 1-23. 2.8 21 min. Personal-Same as 1-23. 1.8 30 min. Personal-Wet mix operator (Lester Taylor) at control panel. 0.4 25 min. Personal-Palletizer operator (John R. Green) driving towmotor, transporting pallets & controlling palletizer. 0.6 27 min. Environmental-In warehouse 3' from asbestos pallets 5V off floor during normal activity. 0.2 SGP 0007723 UNION CARBIDE CORPORATION MININS & METALS DIVISION P.O. BOX S79 NIAGARA FALLS. N. T. 14302 ' TEL 716-278-3376 August 16, 1974 Mr. Har-y Scharf Georgia Pacific Corp. P.O. Box 129 Milford, VA 22514 Dear f '. Scharf: 'nclosed is the report of the air sampling conducted at your plant on Jul 31. As always, if you have any questions, please do not lesitate to contact either Gordon Dickson or myself at the above address. EJK/mlv Enclosures cc: G. L. Dickson SGP 0007724 OBJECTIVES Monitor airborne asbestos fiber at Georgia Pacific Corp., Milford, VA, a manufacturer of ready-mix tape joint compounds. OPERATIONS MONITORED 1) Dry mix operator - Basic responsibilities include gathering of raw materials, weighing them and adding them to the hopper. Materials are then conveyed along to the wet mix area, four breathing zone samples were collected here because it can be logically assumed that this job generates the most airborne asbestos fiber. 2) Wet mixer operator - Job consists of operating a control panel which blends bulk handled materials and ingredients sent from dry mix operator with liquids. A breathing zone sample was collected at this point. 3) Palletlzer operator - Carts off completed pallets to warehouse and makes sure palletizer is operating properly. A breathing zone sample was collected at this point since this operator moves freely about the plant and represents a cross-section of in-plant air. 4) Warehouse - An environmental sample was collected in the arei. of stored asbestos. EQUIPMENT AND PROCEDURE . Sampling and dust counting were carried out in accordance with OSHA Regulation 1910.93a, using the Bayer, Zummalde and Brown method for counting asbestos fibers by phase contrast microscopy (Bureau of Occupational Safety and Health, Feb. 1969). Battery-powered air pumps (M.S.A. type) calibrated to 2 liters per minute were used to collect personal breathing zone and environmental samples on millipore membrane filters of 0.8 micron porosity. Fiber counting was performed on a Vicker's phase contrast microscope utilizing a Porton reticle for sizing and field definition. TEST RESULTS Reported as fibers greater than 5 microns in length per cubic centimeter of air sanpled. A fiber is defined as a material having an aspect ratio greater than 3:1 SGP 0007725