Document k6Lg4KeMgj3Kk8d2ynowxwGbV

Cate Na:ie 'CIS?.: Oklahoma A. & if. i Oper'.tlor. NO. IJL0U 12-6-1*9 to 12-8-1*9 Stuart Getz 12-10-U9 Stuart Getz to 12-12-1*9 12-13-U9 12-1U-U9 and 12-16-4*9 Stuart Getz 12-19-U9 Stuart Getz 1-3-50 to 1-6-50 . & 1-9-50 Stuart Getz 1-10-50 and 1-11-50 Stuart Getz 1-12-50 to l-17-50 Stuart Getz 1-18-50 Stuart Getz Steamfitters still working on all three units. Insulation men working also. Other routine work preparatory to running un ..Getting units: ready for flushing oil. Had to make up new piping from regulator to pump, offsetting the regulator. i Steamfitters still working. Fitting steel lagging on all units. Will circulate flushing oil whenever steam is. available Routine work. ; . . Working on fitting up piping for gland condensers and putting brush holders back on generators. Fitting steel lagging for around collector ring assembly. Steam, fitters working.on non return oil piping. Working on steel lagging around extraction regulator, took regulator apart; to clean up, it was heavily rusted on inside. Pipefitters still working. Removed the extraction regulator from the A unit - it was badly rusted on the inside, cleaned up... Steamfitters working on pipir to gland condensers. Steamfitters working on piping to gland condensers. Working on steel lagging. 3-15-50 Stuart Getz U-6-50 Stuart Getz Went out to job! to make arrangement to get help for changing springs in non--return valves. The weight levers on the non-return valves interfered with the concrete foundation due. to differences in the piping drawin; Corrected. . ! L-13-50 Stuart Getz Shipped the springs removed ffcemtthe non-return valves to Ataood and MbrxHi.ll Co. 6-ili-5o to 6-19-50 Stuart Getz Routine -work 1 put flushing oil in, started aux. oil pump, several oil leaks in field welds, repairing same. Cleaned strainers. Rah circulating oil. Started to clean up gov. linkage. 6-20-50 to 6-28-50 Stuart Getz - EXHIBIT l _3V_br\ th/S'ty iWUl Routine work. Started turbine -- came up to 11*00 rpm and the front end becalms rough. Shut down and removed steam end bearin. and gov. housing. Removed gov. and made adjustments to the won setting. The worm wheel did not have enough backlash, and oil spray pipe did not spray oil in right direction. Corrected. Started unit again and operation o.k. Started aux. oil ponp and made adjustments to gov. linkage. ' ET-00111A r-- i i s - n A K.9\/