Document jyNKre4Vv3yk1843o31EdJRO9

AT&T Asbestos Awareness Course #600519 US REGULATIONS (Continued) CONSTRUCTION AND MARITIME STANDARD SUPPLEMENT (Continued) Work Class and/or Activity Class III of Construction and Maritime Standard Class IV of Construction and Maritime Standard Asbestos impregnated asphaltic materials General industry work activities Worker Protection [1910.1001(g) & (h), 1926.1101(h) & (i), 1915.1001(h) & (i)] Respiratory protection is required where a "negative exposure assessmenf has not been produced (and documented) for all class III work Respiratory protection is required where TSI or surfacing ACM is being disturbed Provide an equipment room or area adjacent to the work area if the work is in a reaulated area, or involves TSI or surfacing ACM Respiratory protection and dean-up facilities are required if cleaning up in a "reaulated area" at the same level of Drotection reauired for the Class 1. II or III workers Provide decontamination area if work involves the cleaning up of TSI or surfacing ACM. The area is as specified for Class III work Respiratory protection is required if roofing materials will not remain intact, or if materials will not be removed wet or in a quantity greater than one glovebag will be removed, regardless of work procedure. If non-wet methods are used on sloped roofs, respirators need not be worn when a negative exposure assessment has been made and the ACM is removed in an intact state. Respiratory protection is required if work practice controls are not feasible (or for the interval until they are feasible), if the PEL is exceeded, or during emergency asbestos fiber release episodes. Work Class and/or Activity Both Class III and Class IV of Construction Standard Class III of Construction and Maritime Standard Class IV of Construction and Maritime Standard Asbestos impregnated asphaltic materials General industry work activities Work Practices [1910.1001(f), 1926.1101(g) and 1915.1001 (g**)] Wet methods HEPA filtered equipped vacuums to collect all ACM debris and dust Prompt clean-up and disposal of waste and debris *NO compressed air used to remove asbestos NO dry sweeping *NO smoking in work areas where employees are occupationally exposed to asbestos because of activities in that work area Local exhaust ventilation, to the extent feasible *Use dropcloths, glovebags, mini-enclosures, and/or other means of isolation when drilling, cutting, abrading, sanding, chipping, breaking or sawing TSI or surfacing materials Waste and debris to be cleaned up, where friable TSI or surfacing material is accessible, shall be assumed to contain asbestos Wet methods unless on a sloped roof and materials will be removed (or worked on) intact *Wet methods NO sanding of floor tile Buffing of floor tile only at low speeds (less than 300 rpm), and with non-abrasive pads 30 a ATT-NJ-DEG-0077617