Document jBQVb9EmdZ4ygX5pd79nVDb1y

Methoda of Asbestos Removal wrmiw a. The aabeatoa material will be sprayed with water containing an additive to enhance penetration. The additive, or wetting agent, will be 50 percent poly ethylene ester and 50 percent polyoxyethylene ether at a concentration of 1 ounce per 5 gallons of water. A fine spray of this solution must be applied to pre vent fiber disturbance preceding the removal of the asbestos material. The asbestos will be sufficiently saturated to prevent emission of airborne fibers in excess of the exposure limits prescribed in the OSHA standards referenced in these specifications. b. Removal of the asbestos material will be done in small if needed. The material will be packed into labeled 6-mil plastic bags held within 55-gal drums prior to starting the next section to prevent the material from drying. c.' Packed ari$^aied drums, with the required labeling, v.'.y. . ( >;*r will be delivered to a predesignated disposal site for ----- . . ,N. .fVi*.- burial, labels and all necessary signs shall be in d. Following removal, the entire area will be wet cleaned. After a 24-hour period to allow for dust settling, the entire argjjwill be-wet cleaned again. Durigf*Ki* settling period, no entry, activity, or ventilation will F-4 8006 0385 A. * PRODUCED BY FORD