Document g234B5voeEZ9p7BRg4rDB8k8N

Pm chemicals Material USSCODENO. C1018A ORIGINAUSSUEDATE: W/IMS PREVISED: i. IDENTIFICATION PRODUCT NAME; Soybean Oil Epoxide COMMON NAME(S): Soybean Oil, Epoxidized; PX-800 CAS NO. 8013-07-8 UN/NA NO. Not Applicable DOT HAZARD CLASS; Not Applicable INFORMATION k EMERGENCY TELEPHONE NUMBERS (412) 433-6840 (8 a.m. -- 5 p.m., Mon.-Fri.) (412) 433-6811 (Off Hour Emergencies) FORMULA; Not Applicable MANUFACTURER: U. S. Steel Corporation P. 0. Box 206 (MSDS) Pittsburgh, PA 15230 II. INGREDIENTS AND RECOMMENDED OCCUPATIONAL EXPOSURE LIMITS % WT. EXPOSURE LIMITS OSHA-PEL acgih-tlv HAZARD DATA Soybean Oil Epoxide 99 None None Generally recognized as a Established Established low industrial hazard III. PHYSICAL DATA BOILING POINT (F.) Greater Than 300 SPECIFIC GRAVITY (H20=1) SS'C 0.994 MELTING POINT(*F.) Not Applicable PERCENT, VOLATILE BY VOLUME(%) Negligible VAPOR PRESSURE (mm Hg.) Negligible pH Not Applicable VAPOR DENSITY (AIR = 1) Greater Than 10 SOLUBILITY IN WATER Not Known APPEARANCE AND ODOR: Liquid, mild odor ) IV. FIRE AND EXPLOSION HAZARD DATA FLASH POINT (method used) C0C 600 F EXTINGUISHING MEDIA Water fog, carbon dioxide, dry chemical SPECIAL FIRE FIGHTING PROCEDURES None UNUSUAL"fTre"AND EXPLOSION HAZARDS None FLAMMABLE LIMITS ____ hint Known_____ Lei Uel V. REACTIVITY DATA Stability Unstable Stable X INCOMPATABILITY (materials to avoid) None CONDITIONS TO AVOID: None HAZARDOUS DECOMPOSITION PRODUCTS Carbon dioxide, carbon monoxide, water Hazardous May Occur CONDITIONS TO AVOID: Use low steam pressure to avoid hot spots which Polymerization Will Not Occur X VI. SPILL OR LEAK PROCEDURES might cause polymerization. TRANSPORTATION EMERGENCIES Call CHEMTREC 800-424-9300 STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED: If material is hot or comes in contact with hot objects, fumes may result. Avoid excessive breathing of fumes. Remove igni tion sources. Dike to prevent runoff. Flood with water, then cover with sand or sawdust. Remove and place in labelled drum. In case of release to the environment report spills to 800424-8802, The National Response Center, VWSTE^lSPOSALMETHODT ~.... ' T~EPA Waste Identification No, Not-Applicable Dispose of in accordance with local, state, and federal regulations. For hazardous waste regulations call 800-424-9346, the RCRA Hotline, CHARDO 02258 VII. HEALTH HAZARD DATA EFFECTS OF OVEREXPOSURE: Soybean OH Epoxide MAJOR EXPOSURE HAZARD INHALATION: Due to its low vapor pressure, the Inhala tion exposure hazard potential Is regarded to be low. i | INHALATION [*] CONTACT [*] CONTACT { ) INGESTION However, If the product is heated,It may produce mists which may be irritating to the eyes, nose, throat and upper respiratory tract, SKIN CONTACT: Excessive exposure may produce at least mild Irritation. EYE CONTACT: May produce at least mild Irritation, INGESTION: May cause nausea, vomiting and diarrhea. The chronic health effects of this product have not been determined. EMERGENCY AND FIRST AID PROCEDURES: INHALATION: Remove from exposure. If breathing is difficult or has stopped, administer artificial respiration or oxygen as indicated. Seek medical aid. SKIN CONTACT: Remove contaminated clothing. Wash skin thoroughly with soap and water. Seek medical aid. EYE CONTACT: Flush with targe amounts of water, lifting the tower and upper lids occasionally. Seek medical aid. INGESTION: Give 1-2 large glasses of water or milk, induce vomiting. Seek medical aid. VIH. SPECIAL PROTECTION INFORMATION RESPIRATORY; Respiratory protection approved by NIOSH/MSHA for protection against organic vapors should be used to avoid inhalation of excessive air contaminants. Appropriate respirator selection depends on the type and magnitude of exposure.; SKIN: Chemical resistance data for barrier materials used should be determined based on the use of this product. Natural rubber, neoprene, polyvinyl chloride and nitrile protective garments have been suggested for protection against materials of this chemical class (ACGIH-Guidelines for the Selection of Chemical Protective Clothing, 1983). A face shield should be used when appropriate to prevent contact with splashed materials. EYE: Employees should be required to wear chemical safety goggles to prevent eye contact. VENTILATION: Local exhaust ventilation should be used to control the emission of air contaminants. General dilution ven tilation may assist with the reduction of air contaminant concentrations. OTHER PROTECTIVE EQUIPMENT: Emergency eye wash stations and deluge safety showers should be available in the work area. IX. SPECIAL PRECAUTIONS PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: High viscosity material at low termperatures. Recommend pumping at 40 C. OTHER COMMENTS: None This information is taken from sources or based upon data believed to be reliable; however. Untied States Steei Corporation makes no warranty as to the absofute CHARDO 02259