Document dn2BEpQJYJZqDX2vpMaKmJjge

> 4. PLAINTIFF'S EXHIBIT GP-1449 AIRBORNE FIBER COUNTS for Georgia Pacific Corp. Milford, VA August 15, 1974 Samples Collected and Analyzed By: E. J. Kleber Union Carbide Corporation Union Carbide Corporation Mining and Metals Division Niagara Falls, New York SGP 0022073 SUMMARY OF FIBER COUNTS Sample Sample No.TimeDescripti on >5^ 1-23 5 min. Personal-Dry mix operator (John J. Green) gathering, weighing and adding raw materials to hopper. 30 lbs. SG-210 & 78 lbs. Canadian used per batch. G-3 41 min. Personal-Same as 1-23. 1-31 21 min. Personal-Same as 1-23. H-22 21 min. Personal-Same as 1-23. G-10 30 min. Personal-Wet mix operator (Lester Taylor) at control panel. J-8 25 min. Personal-Palletizer operator (John R. Green) driving towinotor, transporting pallets & controlling palletizer. J-13 27 min. Environmental-In warehouse 3' from asbestos pallets 5V off floor during normal activity. Fibers/cc 4.1 0.9 2.8 1.8 0.4 0.6 0.2 SGP 0022074 THE DISCOVERY COMPANY UNION CARBIDE CORPORATION MINING & METALS DIVISION P.O. BOX 579 NIAGARA FALLS, N. Y. 14302 TEL: 716-278-3376 August 16, 1974 Mr. Harry Scharf Georgia Pacific Corp. P.O. Box 129 Milford, VA 22514 Dear Mr. Scharf: Enclosed is the report of the air sampling conducted at your plant on July 31. As always, if you have any questions, please do not hesitate to contact either Gordon Dickson or myself at the above address. EJK/mlv Enclosures cc: G. L. Dickson Customer Service Representative SGP 0022075 OBJECTIVES Monitor airborne asbestos fiber at Georgia Pacific Corp. , Milford, VA, a manufacturer of ready-mix tape joint compounds. OPERATIONS MONITORED 1) Dry mix operator - Basic responsibilities include gathering of raw materials, weighing them and adding them to the hopper. Materials are then conveyed along to the wet mix area. Four breathing zone samples were collected here because it can be logically assumed that this job generates the most airborne asbestos fiber. 2) Wet mixer operator - Job consists of operating a control panel which blends bulk handled materials and ingredients sent from dry mix operator with liquids. A breathing zone sample was collected at this point. 3) Palletizer operator - Carts off completed pallets to warehouse and makes sure palletizer is operating properly. A breathing zone sample was collected at this point since this operator moves freely about the plant and represents a cross-section of in-plant air. 4) Warehouse - An environmental sample was collected in the area of stored asbestos. EQUIPMENT AND PROCEDURE Sampling and dust counting were carried out in accordance with OSHA Regulation 1910.93a, using the Bayer, Zummalde and Brown method for counting asbestos fibers by phase contrast microscopy (Bureau of Occupational Safety and Health, Feb. 1969). Battery-powered air pumps (M.S.A. type) calibrated to 2 liters per minute were used to collect personal breathing zone and environmental samples on millipore membrane filters of 0.8 micron porosity. Fiber counting was performed on a Vicker's phase contrast microscope utilizing a Porton reticle for sizing and field definition. TEST RESULTS Reported as fibers greater than 5 microns in length per cubic centimeter of air sampled. A fiber is defined as a material having an aspect ratio greater than 3:1 SGP 0022076