Document Znjx5en8MJw3xGYmen21rwYQ0

V Monsanto MONTAR COMPOUNDS Monsanto Technical Bulletin No. 0-139 August, 1956 Monsanto Chemical Company, Organic Chemicals Division, $t. Louis 1, Mo. MONTAR COMPOUNDS GENERAL INFORMATION Montar* compounds are a series of high-melting, dark colored polyphenyls. Each has a characteristic range of properties. Montar 3, 4, 5 and 6 are chlorinated polyphenyls; Montar 9 is a mixture of straight polyphenyls. All of these compounds are effective as low-cost binders or tackifiers, for adhesives, mastics, or hot-melt systems in which dark color is not objectionable. They are readily incorporated in rubber base adhesives for paper by first dissolving the Montar in a suitable solvent. (See Solubility Data, page 3.) The chlorinated polyphenyls (Montar 3, 4, 5 and 6) contribute .flame resistance to specialty asphalt products; concentrations of 30% or more yield products with in stantaneous flame-out. All Montar products are compatible with polyvinyl chloride up to about 10 parts per 100 parts of resin, and can be used as extender-type plasticizers to reduce formulat ing costs. Their composition suggests that they may be useful as plasticizers for a variety of other synthetic resins. Montar compounds are readily available in large quantities. Sample quantities may be obtained. This bulletin presents sample formulations and information helpful in the development of new formulations. fit, - r*/Wc.% H ,, .. TV to ^ f)' S- ** I ,, >1 on or. - s The information contained lit thie bulletin It, to our bool knowledge, but and accurate, but all recommandetlone or uifoollont ort mod* without guarantee, olnco tho condition! of uoo art beyond our control. Tho Monoanto Chemical Company ditclalmo any liability incurred in connection with the uee of theee data or auggeetione. Furthermore, nothin! contained herein ahall be conetruod at a recommendation to wee any product in conflict with ealellnt petenti covartni any material or ita uee. . __.*Montflri Reg- V. 8. Phi. Oil. This replaces Monsanto Technical Bulletin P-116. n TOWOLDMONOQ39526 APPLICATIONS Additives for Asphalt All the Montar products are compatible with asphalt at ratios up to two parts for each part of asphalt. As illus trated in the table (below), Montar No. 4 (polychlorinated polyphenyl) contributes flame retardance at con centrations as low as 10%, with instantaneous flame-out above 30%. This property is caused by the formation of an intumcscent layer on the surface of the mixture, which "snuffs" out the flame. Composition Pure Asphalt 10% Montar No. 4 20% Montar No. 4 30% Montar No. 4 50% Montar No. 4 60% Montar No. 4 Flame-out Time 210 seconds 90 seconds 10-20 seconds Instantaneous Instantaneous Instantaneous Both softening point and brittleness of the asphalt blend are increased as the concentration of Montar is increased. Blending is accomplished by thorough mixing, using heat where necessary. Use in Rubber Adhesives A 50% solution of either Montar No. 4 or No. 5 mixed with a 60%-solids rubber emulsion (1:1 ratio) yields a paper adhesive with good tack. Emulsified Montar The emulsifiability of all the Montar products suggests additional applications in the adhesives field. In a recent test, 5% of an emulsifier was added to a 50% solution of Montar, then the mixture was progressively diluted with water. The emulsion did not break until water dilution reached 160%. Use in Vinyls Up to 10 parts of any Montar can be blended with 100 parts of polyvinyl chloride resin by simple mixing. TYPICAL PROPERTIES OF MONTAR COMPOUNDS Property Softening Point (ASTM), C. Acidity Chlorine, % CaO, % Fe, % Flash Point Fire Point Montar No. 3 Polychlorinated Polyphenyts Montar No. 4 Montar No. 5 Montar No. 6 120-170 140- 200 180- 250 150-210 50-52 5-10 0.3 - 0.6 570 F. (298 C.) Above 650 F. 54-56 5-10 0.5-1.0 None None 53-56 1-3 0.1-0.2 None None 59-61 2-5 0.2-0.4 None None Polyphenyl Montar No. 9 130-160 0.1 -0.3 mg. NaOH/gm. None ..... , 0.2 - 0.4 495 F. (257 C.) 580 F. (304 C.) -20620730 TOWOLDMONOQ39527 SOLUBILITY DATA Montar No. 3 A 5 6 9 Benzene vs vs vs vs vs Key: I--.Insoluble VS8---Very slightly soluble SS -- Slightly soluble S-- Soluble VS -- Very soluble Toluene vs vs vs vs vs Kerosene s s vs vs SS Methanol SS SS SS SS I Acetone vss vss SS SS SS AVAILABILITY All Montar compounds are commercially available from Monsanto's Organic Chemicals Division in St. Louis (]\ 0. Box 478), Missouri. TOXICITY AND SAFE HANDLING INFORMATION No formal toxicity data exist on Montar compounds. As a general precaution, prolonged skin contact should be avoided, especially when working with solutions of the compounds. Otherwise, the compositions can be handled in the same manner as roofing tar. WW:MS SM 656 2-3- Prlnted In U.6.A. 0620731 TOWOLDMONOQ39528 MONTAR COMPOUNDS . Monsanto Technical Bulletin No. 0 -1 3 9 August, 1956 For further Information on the product* described In this bulletin contact the nearest Monsanto office. MONSANTO CHEMICAL COMPANY ST. LOUIS AKRON ATLANTA BOSTON CHICAGO CINCINNATI CLEVELAND DETROIT HOUSTON LOS ANGELES MINNEAPOLIS NEW YORK SAN FRANCISCO SEATTLE WILMINGTON MONSANTO CHEMICALS LTD. London MONSANTO CHEMICALS (AUSTRALIA) LTD. Melbourne MONSANTO (CANADA) LTD. Montreal Toronto Vancouver Representatives in the Principal Cities of the World 0620732 TOWOLDMONOQ39529