Document ZJdBkXDR1QyxgEQmM5njxG7k0

CARRIER SECTION Figure 163 Measure each shim separately with a microm eter and add together to get total shim pack thick ness. If baffle is required, it is to be included in the shim pack. If slinger is used between the inner bearing cone and thrust face of pinion, the slinger is also to be measured and included as a part of the total shim pack. Figure 165 Assemble the outer pinion bearing cup into carrier as shown. Tools--#D-144 Cup installer, #C-4171 Handle. Figure 164 ioo-u4 Place the required amount of shims (and baffle if used) in the inner bearing bore; drive the inner bearing cup into carrier with tools as shown. Tools--#D-145 Cup installer, #C-4171 Handle. Figure 166 1009-1 it Assemble inner bearing cone (and slinger if used) on pinion, place bearing installer over pin ion shaft as shown. Drive bearing on shaft until it is completely seated. Tool--#W-262. 45