Document ZJXJ2LZy9J0EBVMG5k2pK3yrL

MACHINING LESSON TWO-DEMONSTRATION 2 5. Measure the rotor minimum thickness. Measure the rotor at the thinnest point in the pad contact area using a brake micrometer. Compare measurements to the specification in the workshop manual or the number cast into the rotor. The rotor must have sufficient thickness to be at or over minimum specification AFTER machining. If the rotor does not have sufficient thickness then clean the hub (step 6) obtain a new rotor, and proceed to step 10. Brake System Diagnosis and Repair September, 2005 83