Document ZBKbnGxowQYjqR7Gb4KnNrmqJ

Calaveras Asbestos Ltd. . MATERIAL SAFETY DATA SHEET Date of Preparation November 12, 1985 Emergency Telephone Number "CHEMTREC" - 1-800/424-9300 SECTION I -- PRODUCT IDENTIFICATION Chemical Name & Synonyms: Chrysotile Asbestos Trade Name & Synonyms: Asbestos Chemical Family: Fibrous Mineral Silicates Typical Formula: Mg^XS^O^)(OH)^ SECTION II -- HAZARDOUS INGREDIENTS Ingredient Percent Occupational Exposure Limits PEL TLV Vapor Pressure Chrysotile Asbestos C.A.S. Number: #12001-29-5 Approx. 100% U.N. Shipping Number: 2590 (white asbestos) H.M. I.S. Rating Numbers: 2 fibres/cc 8 hr. TWA Ceiling Con centration 10 fibres/cc Chrysotile2.0 fibres/cc ACGIH, , Documentation of TLVs at 27 OSHA Standard at 29 CFR 1910.1001 N. A. Health-*(Possible Chronic Effects) Flammability-0 Reactivity-0 Fibres measured are those longer than 5 microns. SECTION III -- PHYSICAL DATA Boiling Range: N/A Volatile Volumne: N/A Specific Gravity (^0=1): 2.4-2.6 Appearance and Odor: White fibrous dry mate rial-no odor Vapor Density: N/A Evaporation Rate Faster/Slower than Ether: Wt/Gal: Variable N/A P.O. Box 127 Copperopolis, California 95228 Telephone (209) 785-2201 Telex 359458 CALACOPL NOV. 22 1985 D 004151 Material Safety Data Sheet November 12, 1985 Page 2 SECTION IV -- FIRE AND EXPLOSION HAZARD DATA Flammability Classification (Non-flammable) Flash Point: N / A OSH A: N/A DOT: N/A LEL: N/A Extinguishing Media: (Use that which is appropriate for surrounding fire) Foam " Alcohol" Foam CO. Dry Chemical Water Fog Other Unusual Fire and Explosion Hazards: None Special Firefighting Procedures: None Section V -- HEALTH HAZARD DATA Effects of Overexposure: Acute - May cause eye and/or skin irritation. Chronic - Overexposure to asbestos can cause asbestosis, a scarring of the lungs. Pleural thickening, effusion, and plaques are nondisabling conditions, seen separately or together, that have been associated with asbestos exposure. The International Agency for Research on Cancer (IARC) has determined that there is sufficient evidence for the carcino genicity of asbestos in humans. Signs and Symptoms of Overexposure: Asbestosis is associated with symptoms of labored breathing, chest pain, weakness and chest tightness. Symptoms are not usually manifest until 15-20 years after exposure. Primary Route(s) of Entry: Dermal Inhalation * Ingestion Emergency and First Aid Procedures: Remove asbestos slivers from skin promptly. In case of eye irritation, gently rinse with water. If irritation persists, get medical help. Special Note: A medical surveillance program must be established for asbestos-exposed persons in accordance with the require ments of the Occupational Safety and Health Administration's standard for asbestos (29 CFR Part 1910.1001). SECTION VI -- REACTIVITY DATA Stability: Stable Hazardous Polymerization: Will Not Occur Hazardous Decomposition Products: None Conditions to Avoid: Avoid creating and breathing dust. Incompatibility (Materials to Avoid): None D 004152 Material Safety Data Sheet November 12, 1985 Page 3 SECTION VII -- SPILL OR LEAK PROCEDURES Steps to be Taken in Case Material is Released or Spilled: Avoid creating dust. Collect dust by HEPA vacuum or in the wet state (wet sweeping, wet wiping) to prevent emission of airborne fibres. Waste Disposal Method: Found at 40 CFR HMCS ipruH fWOVlttoV WdB| Mintom P*ch owner or operator of any source covered under the provision* of 11 81444-91.149 dull: (a) Deposit aQ sabestcs-contafaing waste material at waste disposal sites operated in accordance with the provisions of 101.130; and . (b) Discharge no visible emissions to the outside air during the collection, processing (including incineration), packaging, transporting, or deposition of anjr asbestos-containing wasts material generated by the source, or use one of the disposal methods spedSed in _ . paragraphs (b)(1), (2). or (3) of this- ` section, as follows: (1) Trial tabesto*-containing waste material with water (1) Mix asbestos waste from control devices with water to form a sluny: adequately wet other asbestoscontaining waste material: and (U) Discharge no visible emissions to the outside air from aAect>on."mbdngT end trotting operations, or use the methods specified by 181454 to dean amissions containing particulate asbestos material before they escape to, or ere vented to. the outside air. and (Hi) After watting, seal all asbestos- containing waste material in leak-tight container* while wet aad ~ . (iv) Libel the container* specified in paragraph (b)(l)(iii) as follows: CAUTION Contains Asbestos-. ' Avoid Opeetog or ` (Nttklag CoBtiiw fcseihtag Asbestos is hazardous WYoer Health _ .......... .. Alternatively, use warning labala specified by Ocespstional Safety and Health Standards o< the Department of Labor. Occupational Safety and Health Administration (OSHA) under 29 CFR 1910.1001tg)(2][iij. (2) Process asbestos-containing waste material into ncnfrieble forms: (I) Form aO ssbeeloe containing waste USM mmm material into nonfriabla pellets or other shapes: and -- . (il) Discharge no visible amissiona to tbs ootsida air from collection sod processing operadocs, or use tbs ... _ - U ww Jam SaW ft* BHWCnmOW-------- *Ga*a>*<m% a** mm Sam Sart. MhRMa. methods specified by 101.134 to clean , plftiCfllltl | asbestos material before they escape to, or are vented to. the outside air. Spacing between any two lines must be at least equal to the height of the upper (3) Use an alternative disposal method of the two lines. that baa received prior approval by the Administrator. . (2) The perimeter of the disposal site must be fenced in a manner adequate to deter access by the general public ftt.tse AcOv* vasts dtoposai arise. To be an acceptable site for disposal of asbestos-containing waste material under || 61.151 and 61.152. an active waste disposal site must meet the requirements of this section. (a) Either there must be no visible amissions to the outside air from any active waste disposal site where asbestos-containing waste material has been deposited, or the requirements of paragraph (c) or (d) of this section must bsmaL (b) Unless a natural barrier adequately deters access by the general public, either warning eigne and fencing must be installed and maintained as follows, or the requirements of paragraph (c)(1) of this section must ba mat (1) Warning signs must ba displayed at aU entrances and at intervals of 100 m (330 ft) or leas along the proparty lias of the site or along the perimeter of the sections of the site where asbestoscontaining waste material is deposited. The warning signs must: (i) Ba posted in euch a manner and location that a person can easily read the legend; and (ii) Conform to the requirements of 31 cm x 36 cm (27* x 16") upright format signs specified in 29 CFR 1910445(dU4) and this paragraph: and (iii) Display tha following legend in the lower panel with letter eizet and styles of a visibility at least equal to those specified in this paragraph. (3) Upon request and supply of apprapriata information, the Administrator will determine whether a fence or a natural barrier adequately deters access by the general public (c) Rather than meet the no visible emission requirement of paragraph (a) of this aactiod) an active waata disposal sits would ba an acceptable site if at the end of each operating day. or at least onca every 24-hour period while the site is in continuous operation, the asbestoscontaining waste malarial which was deposited at tha sits during ths _ operating day or previous 24-hour period is covered with either. (1) At least IS centimeters (0 inches) of compacted nonasbestos-containing malarial, or, (2) A resinous or patroleum-baeed dust suppression agent that effectively ' binds dust and controls wind erosion. This agent must be used as recommended for the particular dust by tha manufacturer of the dust suppression agent. Other equally . effective dust suppression agents may be used upon prior approval by the Administrator. Foe purposes of this paragraph, waste crankcase oil is not considered e dust suppression agent. (d) Rather than meet tha no viaibla emission requirement of paragraph (a) of this taction, an active waste disposal site would bt an acceptable sita if an alternative control method for amissiona that has received prior approval by the Administrator Is used. (Sacs, m and Ml(a) of the Clean Air Act as amended (J U.S.C. 7412.7SCl(a)) psp.ai Tte-4-a.<*! D 004153 Material Safety Data Sheet November 12, 1985 Page 4 SECTION VIII -- SAFE HANDLING AND USE INFORMATION Respiratory Protection: Reusable or single-use air purifying respirator -- for expo sures which do not exceed the PEL by more than 10 X. Powered air-purifying respirator -- for exposures more than 10X, but less than 100X, the PEL. Type "C" continuous flow or pressure-demand, supplied-air respirator -- for exposures more than 100X the PEL. All respirators must be NIOSH/MSHA approved. Ventilation: Local ventilation if engineering controls are inadequate. Protective Gloves: (See "Other Protective Equipment") Eye Protection: (See "Other Protective Equipment") Other Protective Equipment: If the ceiling concentration limit is exceeded, clothing provid ing whole body covering shall be supplied and its use required. Hygienic Practices: Do not create or breathe dust. ' Do not dry sweep or use air hose for cleaning. Do not take protective equipment or clothing home. (See attached pamphlet, "Recommended Practices for Handling Asbestos Fiber".) SECTION IX -- SPECIAL PRECAUTIONS Precautions to be Taken in Handling and Storing: Use no hooks in loading and unloading. Protect containers from damage. Do not open containers in a manner that can release dust without providing proper enclosure or control measures. Use dust suppression control measures, such as ventilation or wet-working, at all stages of asbestos handling, use and disposal. Follow good housekeeping practices, such as wet-wiping dusty surfaces, to prevent accumulation of asbestos-contain ing dust. Avoid inhalation of asbestos. Other Precautions: Smoking greatly increases risk to health. While the information and recommendations set forth herein are believed to be accurate as of the date hereof, CALAVERAS ASBESTOS, LTD. MAKES NO WARRANTY WITH RESPECT THERETO AND DISCLAIMS ALL LIABILITY FROM RELIANCE THEREON. *** a D 004154- tos Fiber orption of heat from friction, i reinforcing material, resis3ulation from heat, cold and operties of asbestos that is of industrial applications n to a group of hydrated characterized by fibrous stos is fairly common to >osits are of commercial fibrous and, in a certain 3 lungs, maximum care csure to asbestos dust can result. kaging, transporting, moving --asbestos efully and in such a of bags and the ately repaired, re* 2S. Any spillage of ip immediately -- after thoroughly 1 be deposited in tions governing s on discharge codes, rules or and use of UNLOADING Unitized loads should be fitted intact to and from holds of ships, and off and on land transport by forklift trucks or other suitable handling equipment. Care should be taken to avoid puncturing the asbestos fiber bags during unloading from ships, rail road cars, trucks or other modes of transportation. Hooks or other sharp instruments should not be used. Loose fiber accumulated during transit should be picked up by vacuum cleaner before unloading. STORAGE For storage, fiber bags should be stacked and moved with care to avoid breakage; protected from, puncture by moving vehicles; and, if possible, should be isolated from traffic in the warehouse and covered to prevent dust generation. To prevent deterioration of stored bags, the principle of first-in, first-out should be followed. HANDLING Maximum possible enclosure and fully effective dust control systems should be provided at all stages of in-plant handling where dust is created, such as in bag opening, fiber dumping and bag disposal oper ations. Loose fiber should be cleaned from work areas by vacuum cleaner, or after thoroughly wetting, by sweeping, and then deposited in covered recep tacles. PROTECTIVE EQUIPMENT Wearing of respiratory equipment approved for pro tection against asbestos dust should be required at all stages of asbestos fiber handling where quantities of dust are generated which cannot be kept within the permissible exposure limits by dust control equip ment or other methods. TRANSPORT Where the use of asbestos requires the transport of loose fiber in open carts or buggies, covers should be used to prevent spilling and dust generation. WASTE MATERIALS Waste materials, such as collected dust and empty fiber bags, should be placed in special closed receptacles and disposed of in such a manner as to prevent the release of dust. Safety practices outlined above in the HANDLING and PROTECT/VE EQUIP MENT sections should be followed during these operations. Ail dust from exhaust systems should be collected and safely disposed of, being careful not to release dust into the outside air. Particular attention should be paid to the protection of employees whose job it is to dispose of collected dust from fabric filter dust collection and similar cleaning operations. t Calaveras Asbestos Ltd. November 21, 1985 Mr. E. E. Wang J-M A/C Pipe Corporation 1051 Sperry Road Stockton, CA 95206 Dear Mr. Wang, Enclosed you will find a copy of our revised Material Safety Data Sheet. As per instructions on your purchase order, when this form is revised, you need a copy. Thank you for your continued business. ' Yours CALAVERAS NATURAL RESOURCES, INC enclosure Terri Cantrell Executive Secretary & Sales NOV. 22 1985 D 004156 P.O. Box 127 Copperopolis, California 95228 Telephone (209) 785-2201 Telex 359458 CALACOPL