Document Yr1pRRXn3bDkk1ZJ0jw05E22E

Hill and Griffith; Company Material Safety Data Sheet May be used to comply with OSHA's Hazard Communication Standard, 29 CFR1910.1200. Standard must be consulted ffa specific requirements. NA = NOT APPLICABLE N.E. = NOT ESTABLISHED I. PRODUCT IDENTIFICATION PRODUCT NAME (s): Concote TM 405 Manufacturer; Address: Telephone: The Hill & Griffith Co.1085 Summer Street Cincinnati, Ohio 45204 (513)921-1075 Fax: EMERGENCY - TELEPHONE: (800) 424-9300 Call Chemtrec (513) 921-9180 II. HAZARDOUS MATERIAL IDENTIFICATION SYSTEM * CATEGORY Flammability RATING 0 Health Reactivity 2 0 Personal Protection A These ratings are based on NFPA regulations LEGEND 0=Minimal Hazard 2=Modcrate Hazard 0=Minimal Hazard A=Safety Glasses III. HAZARDOUS INGREDIENTS HAZARDOUS INGREDIENTS Olivine Bentonite CAS.NO. 1317-71-1 1302-78-9 ACGTH. THRESHOLD LIMIT VALUE 10 mg/m3 % RANGE 60-70 0-10' OSHA PERMISSIBLE EXPOSURE LIMIT 5 mg/m3 Quartz 14808-60-7 -- Respirable Quartz (<l-2%) Nuisance Dust . 0.05 mg/m3 10 mg/m3 0.05 mg/m3 5 mg/m3 * * Total Dust ** Respirable Fraction 5 mg/m3 ** This material contains crystalline silica. The International Agency for Research on Cancer (IARC ) Monograph Silica. Some Silicates and Organic Fibres (Volume 68, 1997) has determined that crystalline silica in the form of quartz or cristobalite from occupational exposures, if inhaled, is carcinogenic to humans (IARC. Group 1). Prolonged inhalation ofsilica dust may result in silicosis, a progressive, disabling, and sometimes fatal, lung disease. Avoid creating dusty conditions and use a NIOSH/MSHA approved dust respirator when Threshold limit Values (TLVs) may be exceeded. This material contains olivine, which contains small amounts ofnickel and chromium compounds. Nickel compounds are classified by IARC as "carcinogenic to humans" (Group 1) and by NIP as "reasonably anticipated to be a carcinogen." Chromium compounds are listed as "unclassifiable as to carcinogenicity in humans (Group 3) by IARC and "Not classifiable as a human carcinogen" by OSHA. HG-000174 jooi 73 1. PRINTED IN U.S.A. HG-000175 0001 Product Name: Concote TM 405 IV. PHYSICAL/CHEMICAL PROPERTIES Appearance and Odor: Gray slurry, no odor. Water Solubility: Miscible. Melting Point(F): 32 Boiling Range(F): 212 Specific Gravity(water=l): NE Vapor Pressure(mmHg): 760 Vapor Density(Air=l): NE TPQ: NA Percent Volatile By Weight: 35-50 t Evaporation Rate(Butyl Acetate=l): < 1 RQ: NA Page 2 V. FIRE AND EXPLOSION INFORMATION Flash Point(C.O.C.)(0F): NA Auto-Ignition Temperature(F): NA Flammable Limits: LEL: NA _ UEL: NA Extinguishing Media: Not applicable Unusual Fire or Explosion Hazards: High concentrations ofdust in high heat environment may cause explosions Special Fire-Fighting Procedures: Use full facepiece with self-contained breathing apparatus when fighting fires near this product VI. CHEMICAL REACTIVITY INFORMATION Conditions Contributing to Instability: High concentration ofdust in a high temperature environment Incompatible Materials: NE Conditions to Avoid: Dusting. Hazardous Decomposition Products: Various oxides of carbon and hydrogen. PRINTED IN U.SA. HG-000176 Product Name: Concote TM 405 VII. HEALTH HAZARDS A. Summary/Risks Page 3 Signs and Symptoms ofOverexposure: Overexposure could result in coughing, sneezing, shortness ofbreath, or other respiratory problems. Other symptoms may result. Medical Conditions Generally Aggravated by Exposure: May aggravate pre-existing medical conditions. Primary Route(s) ofEntry: Inhalation. Target Organs: Eyes, and lungs. Acute Health Effect Overexposure could result in temporary mucous membrane or respiratory tract irritation. rhronic Health Effect Overexposure could result in irreversible mucous membrane or respiratory tract damage. Symptoms include cough, shortness ofbreath, and reduced pulmonary function. This product contains small amounts ofnickel and chromium compounds. Hexavalent chromium has not been detected in the olivine (detection limit 0.1%). Overexposure t nickel and chromium compounds may cause respiratory and skin sensitization. r^rrmoeenicitv- See page 1. In the report the National ToxicologyProgram (NIP) classified respirable crystalline silica, Snruimfficaireinlvt qeuviadretzncdeusotsfcoacrccuinrroinggeniniciitnydfurostmriasltuadnidesocincuhpuamtiaonnsalinsdeitctiangtisn,gaas kcansouwanl rteolabteioanshhuimp abnetcwaerecinnoegxpeons,ubraesteodroenspirab SrrvUsdtaHllinnee ssiilliiccaa-qduuasrttzInasaadndiAtio2nS, uthsepeAcmteedrHicuamnaCnoCnfeerreemncoegeonf.GSoeveerpnamgeen1tafol Irntdaufosrttrniaal fHcyagoiennnisitcsM(AmCGrfIdHm) hmansucmlassifiec compounds in the olivine. Olivine is not considered a carcinogen or suspected carcmogen by IARC. NTP, or OSHA. Notes to Physician: None. VII. HEALTH HAZARDS B. First Aid/Emergency Procedures Inhalation: If overcome, immediately remove from exposure and seek medical attention. Skin Contact/Absorption: Wash skin thoroughly with soap and water. Ifirritation develops, seek medical attention. Eye Contact Flush with clear flowing water for at least 15 minutes. Ifirritation persists, seek medical attention. Ingestion: Ifingested, DO NOT induce vomiting; call a physician immediately. VIII. SPILL, LEAK AND WASTE DISPOSAL PROCEDURES Procedures for clean up ofspills/leaks: Stop spill as soon as possible. Scoop up or clean up using best means possible. Water may be used to clean area. Notify proper authorities if the need exists. Waste Disposal: Waste generated during application, demolition, breakage or spillage may be hazardous wastes as defined by RCRA (40 CFR part 261). Place waste and spillage in closed containers. Dispose ofin approved landfill in accordance with federal, state and local regulations. PRINTED IN THE U.S.A. HG-000177 Product Name: Concote TM 405 Page 4 IX. PROTECTION AND CONTROL INFORMATION Hygienic Practices: Minimize breathing vapors, mists, fumes or dusts. Avoid prolonged or repeated contact with skin. Remc contaminated clothes, .launder before reuse. Remove contaminated shoes; clean before reuse. Ventilation Requirements: Provide ventilation sufficient to prevent exceeding recommended exposure limits Respiratory Protection: Use NIOSH approved respirator for fine particulate filter for dusts, ifPermissible Exposure Limits or Threshold Limit Values are exceeded or if the user deems necessary. Eye Protection: Use safety glasses, splash goggles, or face shield when eye contact may occur. Protective Gloves: Use chemical-resistant gloves, ifneeded, to avoid prolonged or repeated skin contact Other Clothing and Equipment: As required to prevent contact Engineering Controls/Work Practices: Keep containers and storage containers closed when not in use. Special Considerations for Repair/Maintenance of Contaminated Equipment: Provide adequate respiratory, eye and skin protection. X. PRECAUTIONS FOR SAFE HANDLING AND USE Storage Segregation: Always segregate materials by major hazard class. Special Handling/Storage: Do not transfer contents to unlabeled containers). Other: Comply with all federal, state and local regulations. XL DOT SHIPPING REQUIREMENTS Shipping Name(s): Any Packaging Compound, Thermal Insulating Date Prepared: 02/11/02 Prepared by: Lori R. Yeager Supersedes: 08/15/01 Print Date: 02/11/02 Title: Corporate Government Regulatory Specialist As of the date ofpreparation of this document, the forgoing information is believed to be accurate and is provided in good faith to comply with applicable federal and state law(s). However, no warranty or representation with respect to such information is intended or given. PRINTED IN U.S.A. HG-000178 3 6 3 7 Farnsworth Avenue Indianapolis, I N 46241 Sales Centrai-Cincinnati 1-800-543-0425 Sales Centrahlndianapolis 1-800-428-3102