Document Xz5NMOg5Vmedzxxbkro2vvw0B

4. t M ,, :lC niji MaterialSpvecdrfniccaqtulponDM' Matertf Heme ;?% ,.. . ^ If.--.' ^k3SKBT^:ASBBSTOS/KI7BBSR >v 1.1 scope - 1 E X* Spaeffieetion Number ESE-M8G106-A *?>>' (T ... 2. The material defined by this specification is an elastomeric bonded, compressed asbestos sheet, the asbestos being of spinning grade. i APPLICATION ** This specification was released originally for materia) used where resistance to high temp* erature (approximately 649C) and/or high swell in oil is required. 3. REQUIREMENTS rt: ' All tests shall be conducted in accordance with ASTM F 104, Type 1, unless otherwise speci fied. 3.1 COMPRESSIBILITY (ASTM F 36) 7-17% Recovery, min 40% 3.2 TENSILE STRENGTH, min Less than 1/64 in (0.40 mm) Thick (Avg. of 3 tests) 1/64 in (0.40 mm) and Greater 2800 psi (19.3 MPa) 4600 psi (31.0 MPa) 3.3 IMMERSION IN LIQUIDS Thickness change shall be measured with 9 + 0.1 oz (2.5 + 0.03 N) load on gage before immersion end 3 + 0.1 oz (0.83 + 0.03 Nlload on gage after immersion using a presser foot diameter ofO.25 0.01 in"(6.4 + 0.3 mm). Immersion Fluid Test Conditions Thickness Change (Avg. of 3 Tests) Under 1/34 in<0v40^mm) 1/64 in (0.40 mm) And Greater ASTM Oil No. 1 ASTM Oil No. 3 ASTM Fuel "A" ASTM Fuel "B" 5 h at 149 + 3C 5 h at 149 + 3 C 5 h at 23 +~2C 5 h at 23 + 2C 10-25% 80-110% 10-20% 25-55% 3.3.1 Tensile Strength Loss, max (ASTM Oil No. 1, 5 h at 149C) 10-20% 35-75% 10-20% 25-40% 20% 29l loub Date Para. No. Revisions 1_____ -------------------- IwriiTil CI55ZS531964 09 OF ---------- r,- Metrieated, Renumbered & Retyped C r l U - fcD OSSQvlC Released E7-3141 t," *ti 3946*