Document RpmemyRg5bJgvEXE86Y6gwoMB

Page 3 of 3> t .. SECTION VII - Precautions for Safe Handling and Uw \ l _L Steps to Be Taken In Case Material Is Released or Spilled \ * ------------ ,-i^Y Grinding, drilling, milling, etc. can result in the release ol airborne dust. Measures as outlined In SectionjVIII should be followed if this occurs. j Waste Disposal Method Asbestos per 40 CFR, Part 61, 29 CFR, Part 1910.1001 Other Hazardous Ingredients per 40 CFR, Part 261, 262 and applicable State and Local regulations. Other Precautions Specific requirements are covered per OSHA 29 CFR 1910.1025 Pre-employment screening for allergies and histories of skin sensitivities may be beneficial In determining persons sensitive to cashew materials. SECTION VIII - Control Measures Respiratory Protection ( Specify Type) ^jqsh approved lor pneumoconiosis - fibrosis producing dusts Bnd dusts withTLV not lessthan 0.06 mg/M3. .. Ventilation , .v Local Exhaust Recommended for dust sources. Mechanical (General) Not recommended for dust control. ** Special NK oth" Barrier creams for persons, with skin sensitive to cashew resins. Protective Gloves Recommended where skin contact with lead and cashew resins. Eye Protection Should not be needed for normal handling of product. Eye protection Is good practice where dust is propelled by grinding or drilling activities. Other Protective Clothing or Equipment Recommended In dusty atmosphere. This may be required under the OSHA lead standard depending upon exposure levels. Work/Hygienic Practices Employees should be property instructed in the use of control measures as Indicated above when there is a need for it. If dust from this product is produced, unnecessary exposures should be avoided by using a vacuum In place of dry brooming. Use wet method of cleaning for other surfaces. Proper and adequate personal hygiene should be practiced by exposed workers. NA Not Available NK - Not Known Warner SBC-23-000028 Form #2