Document RjOE2NVwrk036gpr3xQ52q9v8

IP :e>Heeding Systems Pomps KRAISSL 297 Williams Ave. Hackensack, N.J. Salpg representatives in principal cities. Pumps and separators for fuel oil burner and heating service; circulators for water service; filters and strainers for oil, water, liquids, air and steam applications. Glass 50 Light Oil Pumps Direct drive for No. 1 to No. 4 oils in clusive. High suction lift; pressures up to 100 psi. Ask for bulletin A-1SS0. Particularly adapted to dirty oil condi tions where extraneous matter would cause seizure in more closely fitted mech anisms. Capacity 1 to 10 gpm. Class 60 M Pumps provide capacities from 2 to 212 gpm; special bearings available for solvent service. Glass 60 Heavy Oil Pumps Reduction drive for heavy oils including No. 6 and blended No. 5--for direct burner operation or booster pump appli cation. Internal gear type, machined to close tolerances for max. vacuum characteristics. Ball bearing, V-belt reduction drive-connected to pump by loose coupling--eliminate side deflection from pump shaft. Suction and discharge in. to 2 in.; capacities 75 to 2100 gpn; pressures to 100 psi. Write for bulletin A-119S Class 72 Separators Strainers or filters for both suction and discharge service on every burner instal lation. Single and duplex units for both standard and high pressure service. De sign features ease of cleaning and inter changeability of separator baskets. Available with Underwriters Labels from % in. to 4 in.; larger sizes up to 6 in. Ask for bulletin A-14S0 iu & K -Sr- ,V UL listed single strainers for installation as integral part of pump type burners. Any practical degree of separation; sizes H in. to 4 in. inclusive. Ask for bulletin A-1S14 Glass 34 Water Circulators Enclosed-impeller type centrifugal pump for both vertical and horizontal mount ings--particularly suitable for high head applications. Ball bearing construction, replaceable wear plate, simplified dis mounting and remounting without com plete disassembly. Capacities up to 140 gpm. Ask for bulletin A-1581 1610 Heating Systems Pomps Skidmore Corporation St. Joseph, Michigan Quality Heating Pumps for over a quarter of a century Write for Bulletin No. 19~A on Type UV Pump Bulletin No. Sl-B on Type CP Pump SKIDMORE TYPE UV PUMP The Skidmore Type UV Condensation Pump, single or duplex unit, is designed for use where returns are too low to permit the operation of horizontal type pumps. Type UV Pump operates very satisfactorily where condensate is to be returned to the boiler or other points, from all types of steam heating systems or process equipment. Type UV Pump consists of vertical pump and motor unit with float and float switch mechanism mounted on cover plate which is bolted to sump type receiver. Capacities 2000 to 40,000 sq ft EDR and discharge pres sures from 10 to 75 lbs. SKIDMORE TYPE CVS PUMP The Skidmore Type CVS Condensate Pump is built for maximum efficiency, requires a minimum of space. Designed in both single and duplex units. Shown , above is the duplex pump with two float 1 switches. This model also furnished with automatic alternator on all sizes. Inte gral pump casing and motor stand of cast iron construction, bolted to top of receiver. Pump bronze fitted throughout, with enclosed centrifugal impeller of spe cial design for hot water. Capacities 500 to 10,000 sq ft EDR, pressures from 10 to 40 lbs. Write for Bulletin No. 14-A on Type HS Pump Bulletin No. 17 on Type TM Pump SKIDMORE TYPE HS PUMP SKIDMORE TYPE TM PUMP The model HS Condensation pump is economically designed to offer maximum efficiency with lower operating cost. The Type HS will operate at high tem perature encountered in condensation pump service. The pump can be dis assembled without disturbing piping connections. Furnished in either single or duplex type. Pump casing is con structed of heavy close grain cast iron, vertically split, bronze fitted throughout. Capacities 1,000 to 65,000 sq ft EDR, pressures 10 to 75 lbs. Type TM pump consists of motor, steel receiver, automatic make-up valve mounted on receiver, water level gage glass mounted on receiver, self-cleaning strainer between pump and receiver, assembled and mounted on steel base. Cast iron base furnished if required. Electric boiler water level controller furnished for mounting on boiler. The Type TM Condensate and makeup water pump is of turbine type designed for boilers up to 250 hp and pressures up to 150 lbs. Write for Complete Engineering Data Bulletins on Skidmore Condensate and Vacuum Pumps will be sent on request 1611