Document RZ91M4y4pqZpdRpQQmoNMpRX

--* "pf- (M- CTyped: II/^^-H/iY/t^ SALE.'j REPRESENTATIVE'S REPORT FRICTION PRODUCTS GROUP CUSTOMER V/ ~^fUfyf ^ type of call l/jTho^UX^.--------------..----- REPRESENTATIVE response requested date , , 11/14/77 REPORT No FRUEHAUF CORPORATION ADDRESS L. E. BRETZ, JR. CITY 7493 STATE/ZIP DETROIT, - MI. PHONE OFFICIALS INTERVIEWED Arnold Przepiora - Director Product Development (Accompanied by Walt Thomas) Andrew Szymanski - Chief Engineer - Components Sharad Sheth - Project Engineer A. G. Schaible - Manager Aftermarket & Accessory Purchasing COMMENTS Per previous arrangements, a meeting was held with the above gentlemen and our Mr. Walt Thomas of Winchester Engineering. A review of their drawings and where the discrepancies are was made. We supplied them with all of our computer print-outs, our calculations, etc., for their review, in an attempt to convince them than their dimensioning on their drawings was not proper. As noted previously, we can provide them with the proper off-set if they change their thickness dimensions and/or can provide them with the proper thicknesses required if they change their off-set dimension. We cannot give them both nor can anyone else in the industry. There was also a request, on our part, to change the thickness specifications of .010 - .020. Ke also noted a discrepancy in their hole diameter and counterbore diameter from our standard. We noted that we could provide them, if necessary, with the dimensions on these holes if they wanted. On Tuesday, November 15, 1977, Mr. Sheth contacted Walt Thomas and the writer inobscentia, noting that we were correct in our calculations and thesis and they agreed with our position. They are forwarding to us, a memo which allows us to deviate from their drawings, until such time as they can get their drawings changed. This memo also states that the original equipment parts can have a thickness tolerance of .020 however, the aftermarket parts (replace ment and OES) will have to have a thickness tolerance of .010. This memo also states that we must comply with their hole diameter and counterbore diameter requests. It appears that everything has been taken care of in this regard and we can, with confidence, go ahead and manufacture parts per our agreement. At this time, I would like to caution all members of our manufacturing group that this is a new customer. We are supplying him volumes of parts on a monthly basis for the first time in history. This change from a single source Carlisle material to a dual source utilizing Abex linings, was not met with enthusiasm by all members of the Fruehauf family. There continues to be disbelievers and people who feel that Fruehauf has made a mistake. There will SCF-ABEX-2065 OBR 04757