Document QMJ4L4eyjnwpd54k8VyggyYRL

VAtSE OF OPERATIC?' OR L3UIFMEJT Serin Drill #2 Strip Drill ix3 Strip Drill f"4 TYPE OF HOOD (DBiENSIC") Down draft (5" x 6") Flexible duct (4" diameter) II FACE VELOCITY I'PIC 800 600 II AIP VCLIT/E CFK 167 50 50 Strip Drill #5 It 500 45 Avey Block Drill Table saw (Block) Block I.D. Grinder Enclosed and exhausted Flexible duct (4" dia.) 3/4 enclosed (13" x 7") tl 1200 800 It -100 500 Comments: 1. A total of five directions were suggested in Dr. Verma's report dated February 6,1973. Out of the five directions, No. 1 and 5 should be considered to be complied with. The company is working on the oener three directions. Two additional directions are suggested in this report. 2. There is an immediate need for proper and unproved local mechanical exhausts for the kneeders. 3. The "Lcdige" mixer should be provided with adequate dust control measures to control the dust dissemination. A. Brusnmg and dry sweeping are still used to clean the equipment. 5. The use of coTipressed air is widespread and freouent. This should stop immediately. The comoany should corsider msiailing a clothes cleaning ctaticn. 6. The number of damaged oags should be reduced to a minimum. 7. The c. is * uv "-xijoi st hooa for the "Dual Saw" is net >'ery effective. A e Jiisjd;r>-t)le r"TK,'j'it of fibres escapes irto t' general area. SPNY 001353