Document O17Gv8ykDXV5q7r4NymbkxoeM

materials combined. .'Animat* means any organ Ism other, than a human being of thekingdom. Animal, distinguished from plants by certain typical characteristics such as the power or locomotion, fixed structure and .. limited growth, and non-photosynthettc metabolism. 'Continuous automatic stoking' means the automatic moving, of animal pathological waste, during .burning, by moving - ,the hearth in .a pulse cycle manner, tdiich ' process `is designed to provide a continuous 'burning rate In which the design charging rate per hour equals the burning rate every hour without limitation, and results in emission rates which are similar over any hour of the burning' process. b) Section 212.181 shall not-apply to continuousautomatic staking pathological waste incinerators if all or the following conditions are met: 1) The Incinerator shall burn animal pathological waste exclusively, except as otherwise prescribed by the Agency during- specified test operation. 2) The Inc 1nerator.;sha11 burn no more than 907 kilograms (2000 pounds) of waste per hour. 3) The Incinerator shall be multi-stage controlled air combustion incinerator having cyclical pulsed stoking hearth. c) No person shall cause or. allow the emission of particulate matter into the.atmosphere from, any incinerator.--.as defined In this section, to excess 1 gram of emission per 1 kilogram of animal pathological waste charge (0.1 lb/100 lb). d) The particulate matter emissions produced when burning animal pathological waste using gaseous auxiliary fuel, such as natural gas. shall not exceed the pound per hour emission rate equivalent to the maximum concentration rate set forth In Section 212.181(d). when applied to burning a maximum or 2000 lb of mixed charge animal pathological waste plus solid.waste for demonstration of compliance. Mixed charge' shall contain no more than 2SI by weight of solid waste other than animal pathological waste.; (Source: Added at 11 111. Reg. 1410. effective Oecember 30. 1986) , SUBPART E: PARTICULATE HATTER EHISSIONS fROM FUEL COMBUSTION EMISSION SOURCES Section 212.201 Existing Sources Using Solid Fuel Exclusively Located in the Chicago Area No person shall cause or allow the emission of particulate matter into the atmosphere from any existing fuel combustion source using solid fuel exclusively, located in the Chicago. Major Metropolitan Area, to exceed 0.1S kg of particulate matter per MW-hr of actual heat Input In alny one hour period (0.1 Ibs/hStu/hr) except as provided In Section 212.203. :($ource: Amended at ,.10 111. Reg. 12637. effective July 9. 1986) Section 212.202 Existing Sources Using solid fuel Exclusively located Outside the Chicago Area No-person shall cause or;allow the emission of part iculate matter into, the atmosphere from any existing fuel combustion-source.uslng solid fuel excluslvely--htrtclris".located -outside the Chicago major metropolitan area, to exceed the limitations specified In the table below and Illustration A In any one hour; period except as ' provided in SectVoa 2U-203. .... (CTUC (WITS H (Ranoel . Itegasflttl S Kilograms aer megawatt . Less `than or, equal to 2.93 1.5S 6reater than 2.93 but smaller than 73.2; 3.33H"*7'5 Greater than or equal to 73.2 0.1SS EKOUSHUMUS ^ r.TWnaer ... mi1.lan.Blu. pcrhouc r.- Pounds..pgr million Ptw less than or equal' to 10 -Greater then 10 but =- smaTTer than"ZSO" 7` 1.0 s.ieiro-TM Greater than or equal 'to-250 0.10.1 where: S s ATTTdwaBTe-eaTjrsfbri standard trr lbs/MBbtu/hr or fcg/Hf of actual, heat input', 'arid H -.... Actual .heat' input Jn million 8tu..per hour or megawatts I (Source: Amended at 10 111. Reg. 12637. effective July 9. 1986) Section 212.203 Existing Controlled.Sources Using Solid Fuel Exclusively Notwithstanding Sections 212.201 and 212.202. ariy existing fuel combustion source using solid fuel exclusively may, in any one hour period, emit up to. but not exceed 0.31 kg/MW/hh (0.2 TBs/Hbto). fr. as or Apf ir rr. r97T. anr <m<r at the following conditions was met: a) The emission source had an hourly emission rate based on original design or equipment performance test conditions, whichever is Stricter, which was less than 0.31 kg/HW-hr (0.20 Ibs/MBtu) of actual heat input, and the emission control of such source is not - SI