Document NeQ3Ln6Vvp8jBNLR667YnDX3g

hPR-24-1995 E*ON CHEMICAL 11:14 FROM TO 8504353B765 iviMitttlAL SAFETY DATA SHEET EXXON CHEMICAL AMERICAS A O.viil.n < EXXON CHEMICAL COMAANT, A CM..,!... of EXXON COAAOaATION P.04 ISOPAR C SOLVENT PAGE: oate prepared: MSDS NO.: 1 apr 3. 1995 928346.42 SECTION 1 CHEMICAL PRODUCT AND COMPANY IDENTIFICATION PRODUCT NAME: ISOPAR C Solvent CHEMICAL NAME: Not Applicable: Blend CHEMICAL FAMILY: Synthetic Isoparaffinic Hydrocarbon PRODUCT DESCRIPTION: Clear colorless liquid. CAS 64741-66-8 CONTACT ADDRESS: EXXON CHEMICAL AMERICAS P.O. BOX 3272. HOUSTON. TEXAS 77253-3272 EMERGENCY TELEPHONE NUMBERS: (24 Hours) ** CHEMTREC (800) 424-9300 ** EXXON CHEMICAL AMERICAS (800) 726-2015 NON EMERGENCY TELEPHONE NUMBERS : (8am-5pm M-F) FOR HEALTH ANO SAFETY INFORMATION CALL : (713) 870-6884 FOR GENERAL PRODUCT INFORMATION CALL : (713) 870-6000 SECTION 2 COMPOSITION/INFORMATION ON INGREDIENTS Tnis product is hazardous as defined In 29 CFR1910.1200. OSHA HAZARD Flammab1e SECTION 3 HAZARDS IDENTIFICATION POTENTIAL HEALTH EFFECTS EYE CONTACT: Slightly irritating but does not injure eye tissue. SKIN CONTACT: Frequent or prolonged contact may Irritate and cause dermatitis. Low order of toxicity. Skin contact may aggravate an existing dermatitis condition. INHALATION: High vapor/aerosol concentrat1ons (greater than approximately 1000 ppm) are irritating to tne eyes and the respiratory tract, may cause headaches, dizziness, anesthesia, drowsiness, unconsciousness, and other central nervous system effects, including death. INGESTION: Small amounts of tnis product aspirated Into the respiratory system during ingestion or vomiting may cause mild to severe pulmonary injury, possibly progressing to death. Minimal toxicity. SECTION 4 FIRST AID MEASURES EYE CONTACT: Flush eyes with large amouhts of water until irritation persists, get medical attention. irritation subsides. If C ntlnu s on pag 2 DO A 061850 CONFTDFNTTAL P=R-24-1995 11:14 FROM TO 850435.JB765 E%ON CHEMICAL MATERIAL SAFETY DATA SHEET EXXON CHEMICAL AMERICAS A 04 *on of EXXON CHEMICAL COMPANY, A Ol.I.lo- ml EXXON CORPORATION =>.E5 ISOPAR C SOLVENT PAGE: DATE PREPARED: MSDS NO.: 2 APR 3. 1995 92634642 SKIN CONTACT: Flush with large amounts of water: use soap If available. Remove grossly contaminated clothing. Including Shoes, and launder before reuse. INHALATION: Using proper respiratory protection, immediately remove the affected victim from exposure. Administer artificial respiration If breatning is stopped. INGESTION: Keep at rest. Call for prompt medical attention. If swallowed. DO NOT induce vomiting. Keep at rest. Get prompt medical attention. SECTION 5 FIRE-FIGHTING MEASURES FLASHPOINT: FLAMMABLE LIMITS: AUTQIGNITION TEMPERATURE: 18 Deg F. METHOD: TCC NOTE: Typical LEL: l.S UEL: 11.6 77 Deg F. NOTE: 750 Deg F. NOTE: Approximate Approximate GENERAL HAZARD Extremely Flammable, material will readily ignite at ambient temperatures. Static Discharge, material can accumulate static charges which can cause an incendiary electrical discharge . "Empty" containers retain product residue (liquid and/or vapor) and can be dangerous. DO NOT PRESSURIZE. CUT. WELD. BRAZE. SOLDER. DRILL. GRIND. OR EXPOSE SUCH CONTAINERS TO HEAT. FLAME. SPARKS. STATIC ELECTRICITY. OR OTHER SOURCES OF IGNITION; THEY MAY EXPLODE AND CAUSE INJURY OR DEATH. Empty drums should be completely drained, properly bunged and promptly re turned to a drum reconditioner, or properly disposed of. FIRE FIGHTING Use water spray to cool fire exposed surfaces and to protect personnel. Shut off "fuel" to fire. If a leak or spill has not ignited, use water spray to disperse the vapors. Either allow fire to burn under controlled conditions or extinguish with foam or dry chemical. Try to cover liquid spills with foam. Avoid spraying water directly into stonage containers due to danger of bo 11 over. This liquid is volatile and gives off invisible vapors. Either the liquid or vapor may settle m low areas or travel some distance along the ground or surface to ignition sources where they may ignite or explode. DECOMPOSITION PRODUCTS UNDER FIRE CONDITIONS No unusual SECTION 6 ACCIDENTAL RELEASE MEASURES LAND SPILL Eliminate sources of ignition. Prevent additional discharge of material, if possible to do so without hazard. For small spills implement cleanup procedures; for large spills implement cleanup procedures and. if in public area, keep public away and advise authorities. Also, if this product Is subject to CERCLA reporting (see Section 15 REGULATORY INFORMATION) notify tne National Response Center. Prevent liquid from entering sewers, watercourses, or low areas. Contain spilled liquid with sand or earth. Do not use combustible materials such as sawdust. Recover by pumping (use an explosion proof or hand pump) or with a Continues on page 3 A 061851 CONFIDFNTTAL .8PR-24-1995 E^ON CHEMICAL 11=15 FROM TO 8504353B7S5 MATERIAL SAFETY DATA SHEET EXXON CHEMICAL AMERICAS A Dt4o < EXXON CHEMICAL COMPANY, A Ol%ten < EXXON C0ftO*AT(OM P.06 ISOPAR C SOLVENT PAGE: DATE PREPARED: MSD5 NO.: 3 APR 3. 1995 92834642 suitable absorbent. Consult an expert on disposal of recovered material and ensure conformity to local disposal regulations. WATER SPILL Elimlnate sources Of Ignition. Warn occupants and shipping in surrounding and downwind areas of fire and explosion hazard and request all to stay clear. Remove from surface with suitable adsorbents. If allowed by local authorities and environmental agencies, sinking and/or suitable dispersants may be used in non-confined waters. Consult an expert on disposal of recovered material and ensure conformity to local disposal regulations. SECTION 7 STORAGE AND HANDLING ELECTROSTATIC ACCUMULATION HAZARD: Yes. use proper grounding procedure STORAGE TEMPERATURE. *F: LOADING/UNLOADING TEMPERATURE. 'F: Ambient STORAGE/TRANSPORT PRESSURE. ramHg: Ambient LOADING/UNLOADING VISCOSITY. cSt: Atmospneric STORAGE AND HANDLING: 0.9 Keep container closed. Handle and open containers with care. Store in a cool, well ventilated place away from incompatible materials. Do NOT handle or store near an open flame, heat or other sources of ignition. Protect material from direct sunlight. Material will accumulate static charges which may cause an electrical spark (ignition source). Use proper grounding procedures. Do NOT pressurize, cut. neat, or weld containers. Empty product containers may contain product residue. Do NOT reuse empty containers without commercial cleaning or reconditioning. SECTION 8 EXPOSURE CONTROLS/PERSONAL PROTECTION EXPOSURE CONTROLS The use of mechanical dilution ventilation is recommended wnenever this product is used in a confined space, is heated above ambient temperatures. or is agitated. Use explosion-proof ventilation equipment. PERSONAL PROTECTION For open systems where contact Is likely, wear safety glasses with side shields, long sleeves, and chemical resistant gloves. Where contact may occur, wear safety glasses with side shields. Where concentrations In air may exceed the limits given in tnis Section and engineering, work practice or other means of exposure reduction are not adequate. NIOSH/MSHA approved respirators may be necessary to prevent overexposure by inhalation. WORKPLACE EXPOSURE GUIDELINES EXXON RECONMENDS THE FOLLOWING OCCUPATIONAL EXPOSURE LIMITS: 400 ppm total hydrocarbon based on composition. Continu s on page 4 Do A 061852 CONFIDENTIAL. .`.6PR-24-1995 11=16 FROM TO 85043538765 ETfcON MATERIAL SAFETY DATA SHEET _ CHEMICAL EXXON CHEMICAL AMERICAS A Di.i.ica < Exxon chemical companv, a EiiiIsh Exxon cobpoaation P.07 ISOPAR C SOLVENT SECTION 9 PAGE: DATE PREPARED: MSDS NO.: PHYSICAL AND CHEMICAL PROPERTIES 4 APR 3. 1995 92834642 SPECIFIC GRAVITY, at 'F: 0.70 at 60 SOLUBILITY IN WATER, wt. X at *F: Less than 0.01 at 77 SP. GRAV. OF VAPOR, at 1 atm (A1r=1): 3.90 Calculated EVAPORATION RATE. n-Bu Acetate^l: 5.6 Approximate VAPOR PRESSURE. mmHg at *F: 63 at 68 Approximate VISCOSITY OF LIQUID. cSt at 0.7 at 77 Approximate FREEZING/MELTING POINT. `F: Less than -76 BOILING POINT. *F: 205 t 225 *F: SECTION 10 STABILITY AND REACTIVITY STABILITY: Stable CONDITIONS TO AVOID INSTABILITY: Not App1 I cable HAZARDOUS POLYMERIZATION: Will not occur CONDITIONS TO AVOID HAZARDOUS POLYMERIZATION: N t Applicable MATERIALS ANO CONDITIONS TO AVOID INCOMPATIBILITY: Strong oxidizing agents. HAZARDOUS DECOMPOSITION PRODUCTS: None SECTION 11 TOXICOLOGICAL INFORMATION Please refer to Section 3 for available information on potential health effects. SECTION 12 ECOLOGICAL INFORMATION No specific ecological data are available for tms product. Please refer to Section 6 for information regarding accidental releases and Section 15 for regulatory reporting informat ion. SECTION 13 DISPOSAL CONSIDERATIONS Please refer to Sections 5. 6. and 15 for disposal and regulatory information. SECTION 14 TRANSPORT INFORMATION DEPARTMENT OF TRANSPORTATION (DOT): DOT SHIPPING DESCRIPTION: PETROLEUM DISTILLATE. N.O.S.. 3. UN 1268. II SECTION 15 REGULATORY INFORMATION TSCA : This product is listed on the TSCA Inventory at CAS Registry Number 64741-66-8 Continues on page 5 Do A 061853 CONFIDENT IAL RPK-24-1'995 11:16 FROM TO 85043538765 EJJJON CHEMICAL MATERIAL SAFETY DATA SHEET EXXON CHEMICAL AMERICAS A 04<om Of EXXO* CHEMICAL COMPANY. A D<v<t<0 of EXXON COOPOOATXO* P.08 ISOPAR C SOLVENT PAGE: DATE PREPARED: MSDS NO.: 5 APR 3. 1995 92834642" Clean Water Act/Oll Pollution Act: This product is classified as an oil under Section 311 of the Clean Water Act (40 CFR 110) and the Oil Pollution Act of 1990. Discharge dr spills which produce a visible sheen on either surface water, or in waterways/sewers wmch lead to surface water, must be reported to the National Response Center at 800-424-8802. CERCLA: This product, as sold, is derived from a fraction of crude oil and is excluded from the sp.111 reporting requirements by CERCLA Section 101(14)(F). When this product is used in a mixture or as an ingredient in another product or in a manufacturing operation, the petroleum exclusion may terminate and an accidental spill may require reporting to the National Response Center at 800-424-8802. This product contains approximately 80% of 2.2,4 Tr1 methylpentane. The reportable quantity of 2.2.4 Trtmethylpentane is 1 pounds. Sara TITLE III: Under tne provisions of Title III. Sections 311/312 of the Superfund Amendments and Reauthorization Act. this product is classified into the following hazarc categories: F i re. This information may be subject to the provisions of the Community Rfght-to-Know Reporting Requirements (40 CFR 370) if threshold quantity criteria are met. Thie product does not contain Section 313 Reportable Ingredients. SECTION 16 OTHER INFORMATION HAZARD RATING SYSTEMS: Tnis information is for people trained in: National Paint & Coatings ASSOClatlon's (NPCA) Hazardous Materials Identification System (HMIS) National Fire Protection Association (NFPA 704) Identification of the Fire Hazards of Materials NPCA-HMIS NFPA 704 HEALTH 1 1 FLAMMABILITY 3 3 REACTIVITY 0 0 KEY 4= 3* 2= 1= 0 = Severe Serious Moderate Siignt Minimal REVISION SUMMARY: Since March 1. 1995 this MSDS has been revised in Section(s): 7. 14 . 15 REFERENCE NUMBER: HDHA-C-25035 SUPERSEDES ISSUE DATE: March 1. 1995 this INFORMATION RELATES TO THE SPECIFIC MATERIAL OE8ICNATCO ANO RAT NOT BE VALID FOR SUCH MATERIAL USED IN COMBINATION WITH any OTHER MATERIALS OS (N ANY PROCESS. SUCH INFORMATION IS To THE BEST OF (X> ANOWLEOCE ANO BELIEF. ACCURATE ANO RELIABLE AS OF THE OATE COUP I LED. HOWEVER, NO REPRESENTATION, WARRANTY OR GUARANTEE IS MAOE AS TO ITS ACCURACY. RELIABILITY OR COMPLETENESS. IT IS THE USER'S RESPONSIBILITY YO SAT1SPY HIMSELF AS TO The SUITABILITY ano COMPLETENESS OF SUCH information FOR his own PARTICULAR USE. WE 00 NOT ACCEPT LIABILITY FOR ANY LOSS OR DAMAGE THAT MAY OCCUR FROM THE USE OF this INFORMATION NOR DO *E OFFER WARRANTY AGAINST PATENT INFR!NCEANT. LAST PAGE A DO A 061854 CONFTDFNTTAL TOTAl. P. 08