Document 9J4Q4LwJeQJvVvowqNRzE34n7

Air System Equipment * Condensers X --- ficmE inousTRiES, me. JACKSON, MICHIGAN, U.S.A. Manufacturers of Quality Air Conditioning and Refrigeration Equipment since 1919 PACKAGED LIQUID CHILLERS EVAPORATIVE CONDENSERS and COOLING TOWERS FLOW-PAC and FLOW-COLD - Factory assembled, completely tested packaged chillers for air conditioning or industrial temperature control. FlowPac capacities: 1% through 5 hp. FlowCold capacities: 3 through 20 tons. FLOW-MIZER Cooling Towers 20 to 175 tons, Evapora tive Condensers to 200 tons. Wide choice of models all blower-type induced draft. Steel parts completely hot-dip galva nized after fabrication. FLOW-THERM Contains proven Acme components pre piped, tested and ready for operation. Direct-drive compressor models from 20 to 125 tons. Available without com pressor to 300 tons capacity. HEAT EXCHANGERS, LIQUID RECEIVERS, OIL SEPARATORS Suction and liquid-line heat exchangers in capacities 3 to 200 tons. Over 70 stand ard sizes of liquid receivers for all re frigerants, plus a full line of oil separa tors for to 100 ton systems. FLOW-COLD TOWERS Extremely compact, lightweight towers. Fan and blower models available m ca pacities from 3 through 20 tons. "FREON" and AMMONIA CONDENSERS ACME DRY-EX CHILLERS For cooling water, brines, and other fluids by direct expansion of the re frigerant. Full range of sizes with wide variety of baffle and head combinations to fit all requirements. Capacities to 300 tons. Full range of combinations to mate . system requirements. Shell-and-tui . shell-and-coil types; horizontal vertical; to 700 tons. Write for catalogs and more information on any ACME product #170 Air System Equipment... Aerofin Corporation 101 Greenway Avenue Syracuse 3, N. Y. A Eft OFIN Standardized Light-weight Heat Exchange Surface There is a factory-trained Aerofin application and service engineer located near yon to give yon prompt service. Write, wire or phone the factory. Aerofin is the modem Standardized Light-Weight Encased Fan System Heat ing and Cooling Surface originated by Fan Engineers to meet the present and future requirements of this highly spe cialized field. All Standard Aerofin Units are furnished as completely en cased Units, ready for pipe and duct connections. The patent casings are built of pressed steel and are exception ally strong and rigid, protecting the Unit from all the strains of pipe connections and expansion or contraction in service. The casings are flanged on both faces,-top and bottom, and template punched for bolting together adjacent Units, or for duct connection. units or for installing in ducts. May be installed either horizontally or verti cally. Used on any two-pipe steam sys tem for preheating or reheating. Modu lating control on preheaters. Available in 13 lengths and 3 widths, from net face area of 2.76 sq ft to 26.28 sq ft. Fig. t Fig. t not*/06" Non'freeze heater (Fig. 1) is built r^6Ze> non"Stratifying spiral fin coil into casing for air conditioning Flexitube Aerofin (Fig. 2) is distin guished from all other developments by its off-set tubes, so arranged as to absorb all expansion and contraction strains. Headers--Steel. Tubing--% in. OD copper, admiralty or aluminum. Joints--Where admiralty or copper tubes are used together with bronze or steel headers tubes are brazed to headers. Where both aluminum tubes and headers are used tubing is welded to headers. Casings--Copper, aluminum or gal vanized iron. Design--Constructed with headers on opposite ends making possible installa tion of units with tubes horizontal or vertical. 171