Document 82NaLmjjkELbkyj36z8J309Ga

Air System Equipment Heat Transfer Surfaces Condensers ACME INDUSTRIES, INC. Jackson, Michigan Representatives in Principal Cities CONTINUOUSLY SERVING THE REFRIGERATION AND AIR CONDITIONING INDUSTRY SINCE 1919 FLOW-COLD CHILLERS AND FLOW- TEMP HEAT PUMPS. Completely pack aged liquid chillers from 2 to 15 tons,, widely used for air conditioning and liquid chilling. Heat Pumps equipped with automatic change-over valves, switches from heat ing to cooling. Water is used as a heat source. EVAPORATIVE CONDENSERS All prime surface for Freon or Ammonia refrigerants--heavy gage sheet metal casings, especially processed for maxi mum resistance to rust and corrosion. Capacities from 5 to 150 tons, all fabri cated steel parts are now hot-dip gal vanized after fabrication. COOLING TOWERS Sizes of induced draft cooling towers to fit practically any application. Sturdily built, hot dip galvanized for long life. HEAT INTERCHANGERS Shell and coil units from 3 to 200 tons capacity. Shell and tube Models from 40 to 180 tons. DRY-EX COOLERS Refrigerant in tubes, solution baffled through shell. For cooling of water, brine, glycols or alcohols by direct expansion of refrigerant. Over 87 models, for all capacities. FREON CONDENSERS AMMONIA CONDENSERS Shell and tube type for use with am monia, Freon or other refrigerants. Standard or special designs to meet varying water temperatures available and condensing temperatures desired. Acme Industries, Inc., also manufacture Flooded water and Brine coolers, Hi Peak Water Coolers, Blo-Cold Industrial Unit Coolers, Pipe Coils, Oil Separators, Remote Room Con ditioners and Liquid Receivers. WRITE FOR CATALOGS ON ANY PRODUCT 1258 Air System Equipment Afro fin Corporation 410 So. Geddes Street Syracuse 1, N. Y. Aero fin Standardized Light-weight Heat Exchange Snrface There is a factory-trained Aerefin application and service engineer located near yon to give you prompt serrice. Write, wire or phone the factory. Aerofin is the modern Standardized Light-Weight Encased Fan System Heat ing and Cooling Surface originated by Fan Engineers to meet the present and future requirements of this highly specialized field. All Standard Aerofin Units are furnished as completely en cased Units, ready for pipe and duct connections. The patented casings are built of pressed steel and are exception ally strong and rigid, protecting the Unit from all the strains of pipe connections and expansion or contraction in service. The casings are flanged on both faces, top and bottom, and template punched for bolting together adjacent Units, or for duct connection. units or for installing in ducts. May be installed either horizontally or vertically. Used on any two-pipe steam system for preheating or reheating. Modulating control on preheaters. Available in 13 lengths and 3 widths, from net face area of 2.76 sq ft to 26.28 sq ft. Fig. t Aerofin Non-freeze heater (Fig. 1) is non-freeze, non-stratifying spiral fin coil built into casing for air conditioning Flexltube Aerofin (Fig. 2) is distin guished from all other developments by its off-set tubes, so arranged as to absorb all expansion and contraction strains. Headers--Steel. Tubing--% in. O.D. copper, admiralty or aluminum. Joints--Where admiralty or copper tubes are used together with bronze or steel headers tubes are brazed to headers. Where both aluminum tubes and headers are used tubing is welded to headers. Casings--Copper, aluminum or galvan ized iron. Design--Constructed with headers on opposite ends making possible installa tion of units with tubes horizontal or vertical.