Document 7R713DErj00XNj6ykZ9oM38DB

1ECAUT10NS tin Bated UlKtbn/Sealcn - example, epoxide and formaldehyde in bated. 05HEALTH AND SAFETY PRECAUTIONS Highly flammable, flammable, combustible. BRAZING - See Welding T9 Used ir* vehicle coojani systems, brake air pressure system*,, 5ci-vr*n*asber solutions. CHEMICAL MATERIALS - GENERAL See Legal Aspects :ing should only be carried out in well tilated areas as harmful or toxic tile chemicals may be released. contact with uncured resins and leners can result in irritation, .atitis, and absorption of toxic or nful chemicals through the skin, thet can damage the eyes. Vapours given olf from coolant antifreeze (glycol) arise only when heated. Antifreeze may be absorbed through the skin in toxic or harmful quantities. If swallowed seek medical attention immediately. ARC-WELDING - See Welding tde adequate ventilation, and avoid and eye contact. Follow the lecturer's instructions. ASBESTOS - See Brake and Clutch Linings and Pads refeic. Cyanoacrylate and Other . lie Adhesives BATTERY ACIDS See Acids and Alkalies Gases released during charging are are irritant, sensitizing or harmful to tin. Some are eye irritants. explosive. Never use naked flames or allow sparks near charging or recently tnd eye contact should be avoided and charged batteries. anufacturers instructions followed. acrylate adhesives (super-glues) must mtact the skin or eyes. If skin or eye is bonded, cover with a clean moist BRAKE AND CLUTCH FLUIDS (Potyalkyiene Glycols) - See Fire Combustible. nd get medical attention. Do not pt to pull tissue apart. Use in well ited areas as vapours can cause ion of the nose and eyes. Splashes to the skin and eyes will be slightly irritating. Avoid skin and eye contact as far as possible. Inhalation vapour hazards do not arise at ambient vo-pack systems see 'Resin Based ves/Sealers*. temperatures because ol the very low vapour pressure. rate (Polyurethane) Adheslvei/Seaiers .esin Based Adheslvcs/Seaiers BRAKE AND CLUTCH LININGS AND PADS - See Legal Aspects uals suffering from asthma or tory allergies should not work with tr these materials as sensitivity ns can occur. raying should preferably be carried -xhaust ventilated booths removing and spray droplets from the ig zone. Individuals working with implications should wear supplied air ors. -EEZE - See Fire, Solvents mple, isopropanol, ethylene glycol, I. These items contain asbestos, which if inhaled may cause lung damage and in some cases, cancer. The normal handling and fitting of these items should not cause any hazard, but any drilling* grinding or filing of friction materials may produce asbestos dust, and should only be carried out under strictly controlled conditions. The dust in brake drums, Me. contajs very UttU asbestos but care should be taken to avoid Inhalation of this dux during servicing of brakes and dutches. The use of drum cleaning units, vacuum cleaning or damp wiping is preferred to the use of air jet* for `blowing-out1. Chemical materials such as solvents, sealers, adhesives, paints, resin foams, battery acids, antifreeze, brake fluids, oils and grease should always be used with caution and stored and handled with care. They may be toxic, harmful, corrosive, irritant or highly flammable and give rise to hazardous fumes and dusts. The effects of excessive exposure to chemicals may be immediate or delayed; briefly experienced or permanent; cumulative; superficial, life threatening; or may reduce life-expectancy. DO'S DO remove chemical materials from the skin and clothing as soon as practicable after sojling. Change heavily soiled clothing and have it cleaned. DO carefully read and observe hazard and precaution warnings given on materia! containers (labels) and in any accompanying leaflets, posters or other instructions. Material health and safety data sheets can be obtained from Manufacturers. DO organise work practices and protective clothing to avoid: soiling the skin and eyes; breathing vapours/aerosols/dusts/fumes; inadequate container labelling; fire and explosion hazards. DO wash before job breaks, before eating, smoking, drinking or using toilet facilities when handling chemical materials. DO keep work areas clean, uncluttered and free of spills. DO store according to national and local regulations. DO keep materials out of the reaohj>f children.' "Tr?fit03co R5 1983 Page 3 8006 1287 HFM - 005873