Document 7MbG89w1kNLvNgRBv5Xm7wn7B

KEENE | Baldwin - Ehret - Hill, Inc. suisioiary CORPORATION TlfNTON, NEW JERSEY DATA SHEET Product: Baldwin-Ehret - Hill #1 Plus Cement Desc ription: Dry mix of spun mineral wool granules, bentonite clay, and asbestos fiber, for mixing with water and application by trowel. After drying, it is effective insulation for heated surfaces. Uses: It is applied as a levelling material over insulating blocks, blankets, etc. , as complete insulation on irregular surfaces, as patching or repair material, or for general insulating and maintenance work. F eature s: No stock problem - one material for all jobs Lightweight - easy application - high plasticity Rust-inhibiting - non-corrosive Reusable if not heated over 1200F Technical Data: Temperature limit-------------------------------------------------------------------------2100 F Mixing water ratio: Cor general use - 12. 5 gallons per bag of 50 pounds - water/cement ratio of 2. 1 (amount governed by plastic Cement Properties: Density - 26 lb. per cu. ft. Thermal Conductivity Mean Temp K 200 F 400 F 600 F 800 F . 57 . 65 . 73 . 83 Coverage, Wet - 50-55 sq. ft. 1 inch thick per 100 pounds Dry Adhesion to Steel - 7 lb. per sq. in. Wet Adhesion - 15-20 Baldwin-Ehret-Hill Wet Adhesion Drop Test, B-E-H-3* Linear Shrinkage after heating at 2100 F - 3% Surface Temperature and Heat Losses - {See Charts) Specifica tions: Federal Specification SS-C-160 Type III Grade Military Specification M1L-C-2861D MIL-I -24244, Type 4 ASTM C 195 U Packaging: Multi-wall paper bags containing 50 pounds each. * Test Procedure available on request Dot*: Oct. 21, 1968 Suporsodos: August 23, 1965 Soction: D-4 Pofl: 1 APPLICATION SPECIFICATION #1 PLUS CEMENT 1. Insulating All mineral wool insulating cement, shall be B-E-H #1 t-lus Mate rial: as manufactured by Baldwin-Ehret-Hill, Inc, 2. Aunlication: B-E-H # 1 Plus insulating cement shall be applied by spotting on a first coat. After this has dried the next coat shall be roughed on or trowelled smooth, depending on total thickness specified. Each coat shall be not over 3/4 inches thick. Thick nesses of 1-1/2 inches and more shall be reinforced with woven wire mesh before applying the final coat of cement. Final coat shall be trowelled level. 3. Finishing: (Alternates ) Hard Surface A 3/8" to 1/2" coat of Super Powerhouse Cement shall be applied and trowelled smooth with a steel trowel. When specified, the surface shall be painted after drying. Canvas After drying the cement shall be covered with 6 or 8 oz. canvas applied with lagging adhesive. Outdoor After drying, the cement shall be covered with woven wire mesh securely fastened, then with 1/4 inch thick B-E-H FibreKote weatherproofing.