Document 6R6rQbjqGOLvrrXe3VYpbpq9m

J1h,V\ ; !979 ATTACHMENT II OSHA Instruction CPL 2-2.20 April 2, 1979 Office of Field Coordination CHAPTER XIII MODIFICATION OF PELS FOR PROLONGED EXPOSURE PERIODS A. Purpose`and `Scope. The 1968 ACGIH Threshold Limit Values (TLVs) adopted by OSHA as permissible exposure limits (PELs) are directly related to assumed conventional exposure periods of no more than 8 hours/day, 40 hours/week. 1. The 8-hour exposure limits for some substances may not provide appropriate protection from health hazards when novel work schedules are utilized; e.g,, exposures longer than 8 hours/day, four 10-hour days/week, six 7-hour days/ week, etc. This chapter identifies those PELs which may * inadequately protect workers for prolonged exposure periods and describes how an "adjusted PEL" may be calculated.- 2. Instructions on sampling and citation procedures shall be sought from the Assistant Regional Administrator (ARA) for Technical Support who shall in turn contact the Directorate of Technical Support. B. Procedure. 1. Each substance listed in the Substance_-Xox.Lc.tty_Iab_le_jLa Chapter II has been assigned to one of the six "Work Schedule" categories described in Figure XIII-1 on the basis of the 1968 Documentation of TLVs published by ACGIH. 2. During a health inspection, the Industrial Hygienist has the responsibility of documenting any work schedules resulting in excessive exposures to a hazardous substance caused by exposure periods longer than 8 hours/day or 40 hours/week. This would include routine overtime shifts. 3. The Industrial Hygienist should determine an "adjusted PEL" as necessary for each hazardous substance sampled, according to the specifications given for the category to which it is assigned. XIII-1 VVV 00OQ0950 OSHA Instruction CPL 2-2.20 A pril 2, 1979 Office of Field Coordination X III-2 Work Schedule Category 1A 10 1C __ 2 3 4 < < < o o o oowon FIGURE XIII-1 Summary of Work Schedule Categories Principle Group Characteristic Celling limit standards Irritants Technologic limitations Acute toxicity only Cumulative toxicity only Both acute and cumulative toxicity Conditions Resulting In Adjustment None None None Exposed greater than 8 hours/day Exposed greater than 40 hours/week Exposed greater than 8 hours/day and/or exposed . greater than 40 hours/week Adjustment Formula None None None AdJ. PEL * PEL X 8 hours/ hours exposed/day Adj. PEL * PEL X 40 hours/ hours exposed/week The equation for category 2 or 3, whichever results in the greatest protection OSHA Instruction CPL 2-2.20 April 2* 1979 Office of Field Coordination 4. No adjustment should be made to the PELs of substances in category 1. For all other categories, the equivalent PELS should be calculated according to the methods described in paragraphs C.l through 6 and used as a professional guide or in the evaluation of actual employee risk. In all situations, the equivalent PEL will be equal to or lower (i.e. more restrictive) than the PEL values listed in 29 CFR 1910.1000. 6. The Industrial Hygienist should also elicit from the employees and document any symptomatology that may be related to the exposure. C. work'Schedule Categories. 1. Category 1A: `Ceiltng Limit Standards. Substances in this category^e.g., butylamine) have ceiling limit stan dards which were intended never to be exceeded at any time, and so, are independent of the length or frequency of work shifts. The ceiling PELs for substances in'this category should not be adjusted. 2. Category`IB; 'Standards Preventing Mild Irritation. Substances in this category^have a PEL designed primarily to prevent acute irritation or discomfort (e.g., cyclopentadiene). There are essentially no known cumulative effects resulting from exposures for extended periods of time at concentration levels near the PEL. The PELs for substances in this category should not be adjusted. 3. Category ~1C: 'Standards Limited by Technologic Feasibility. The PtLs ot suDstances assigned to this category have been set either by technologic feasibility (e.g., vinyl chloride) or good hygiene practices (e.g., methyl acetylene). These factors are independent of the length or frequency of work shifts. The PELs for substances in this category should not be adjusted. XIII-3 WV 00000095,2 OSHA Instruction CPI 2-2.20 April 2, 1979 Office of Field Coordination 4. Category`2:`Acute Toxicity Standards. a. The substances In this category have PELs which prevent excessive accumulation of the substance in the body during 8 hours of exposure in any given day (e.q., carbon monoxide). ^,^^0 ? b. The following equation determines a level which ensures that employees exposed more than 8 hours/day will not receive a dosage (i.e. length of exposure X concentration) in excess of that intended by the standard. Equivalent PH. * PEI. XB hours JSjrs""or~exFosuri""irr"cni""3ay (Equation XII1-1) c. The Industrial Hygienist should normally conduct' sampling for the entire shift minus no more than one hour for equipment set-up and retrieval (e.g., at least 9 hours of a 10-hour shift)'. In situations where an employee works multiple shifts in a day (e.g., two 7-hour shifts), and the Industrial Hygienist can document sufficient cause to expect exposure concentra tions to be similar during the other, shifts, the sampling should be done during only one shift. 5. Category 3.` 'Cumulative Toxicity 'Standards a. Substances assigned to this category present cumulative hazards (e.g., lead, mercury, etc.). The PELs for these substances are designed to prevent excessive accumulation in the body resulting from many days or even years of exposure. b. The following equation ensures that workers exposed more than 40 hours/week will not receive a dosage in excess of that intended by the standard. Equivalent PEI. " 8-hour PEI. X 40 hours Sairs o exposure on one weeT; (Equation XIII-2) XIII-4 VVV 000000953 OSHA Instruction CPL 2-2.20 April 2, 1979 Office of Field Coordination c. It is the responsibility of the Industrial Hygienist to conduct sufficient sampling to document exposure levels for the entire week when evaluating conditions on the basis of this equivalent PEL. For most operations the Industrial Hygienist will be able to sample during one shift only and then document sufficient cause to predict exposure concentrations during the other shifts. 6. Category`4; 'Acute 'and `Cumulative Toxicity Standards. Substances in"this category may present both-an acute and a cumulative hazard. For this reason, the PELs of these substances should be adjusted by either equation XIII-1 or XIII-2; i.e. whichever provides the greatest protection. 7. Refined'Adjustment Equations for Specific Standards. The adjustment equation presented for categories 2 and 3 reflect an oversimplification of the actual accumulation and removal of a toxic agent from the body. Additional research, however, is needed in order to apply more complex equations to estimate resulting body burden and health risk due to prolonqed exposure periods. This chapter will be updated when the necessary data become available. Industrial Hygienists having sufficient data to validate adjusting PELs by a more rigorous method such as those proposed in the following articles are encouraged to do so following approval from the ARA for Technical Support: Brief, R.S. and R.A. Scala, "Occupational Exposure Limits for Novel Schedules," Amer.'"Ind; Hyq; Assn. Jour. 36:467, 1975. :' Roach, S.A., "A More Rational Basis for Air Sampling Programmes," Ann: 'Occup; 'Hyq. 20:65, 1977. Hickey, O.L.S. and P.C. Reist, "Application of Occupational Exposure Limits to Unusual Work Schedules," Amer. Ind. Hyq . Assn . Jour. 38:613, 1977. XIII-5 VVV 0000009*54