Document 5eE2Yvn6eeEXkVy8x33qZ6zz

I r; . F i , !* j - f |? ' ; f.`* * V Engineering Material Specification ApooMoatton Numb* CASKET, ASBESTOS FIBER/ELASTOMRRS-BEATER ADDITION p. ESW-M8G135-A SCOPE A/0 PAST X KEF. -'The materiel defined by this specification is a gasket material compounded from asbestos * fibers and elastomeric polymers. It is produced by the beater addition process. 2 APPLICATION This specification was released originally for material used as rear axle cover plate gaskets. 3. REQUIREMENTS (For 1/32 (0.79 mm) thick material) All tests and conditioning shall be conducted in accordance with ASTM F 104, Type 1, unless otherwise specified. 3.1 COMPRESSIBILITY (ASTM F 36, Procedure "A") 16-25% Recovery, min 40% 3.2 TENSILE STRENGTH, min 1500 psi (10.3 MPa) 3.3 IMMERSION IN LIQUIDS Thickness change shall be measured with 9 0.1 oz (2.5 * 0.03N) load on gage before immersion, and 3 * 0.1 oz (0.83 + 0.03 NJ after immersion, using a presser foot diameter of 0.25 +T.01 in (6.4 * 0.!T mm). Immersion Fluid Test Conditions Thickness Change ASTM Oil No. 1 ASTM Oil No. 3 ASTM Fuel "A" ASTM Fuel "B" 5 h at 149 3C 5 h at 149 ? 3C 5 h at 23 +Vc 5 h at 23 + 2C 20 - 35% 35 - 60% 15 - 30% 25 - 40% 3.4 COMPRESSION SET, max . IASTM D 395, Method "B", 22 h at 70 + 1C, plied to 0.5 in (13 mm)) 60% 3.5 FINISHED PRODUCT Physical and/or performance requirements of finished product, when required, shall be as specified on the affected part or product engineering drawing, or in the affected part or product engineering performance specification. Data Pare. NO. Revision! l<i7f ic cv 1973 02 15 Metricated. Renumbered & Retyped 1 Released PCR 970023 CVI0R-RD-82!4i68 U 001 13B5 I Pace _1_ of _2