Document 5DXRGeJ6OyV3v8Lon5d33zL8

VIII. SPECIAL PROTECTION INFORMATION A. Respiratory Protection: Respirator to comply with OSHA Std. 1910.134 such as 3M 8710 or other NIOSH/MSHA approved respirator, if TLV'a exceeded. B, Local Exhaust; Use adequate exhaust ventilation when grinding or machining to draw dust away from workers to prevent routine inhalation. Do not blow dust with compressor. Mechanical (General) Remove wear dust with vacuum equipment fitted with Hepa Filter. C. Eye Protection; Comply with OSHA 1910.133. Dust may cause temporary irritation or inflammation. If TLV's exceeded, do not wear contact lenses. Goggles recommended if machining. Flush eyes with generouB amount of water if irritated. D. Protective Gloves: If irritation of skin occurs or product is abrasive, gloves may be worn. E. Other: Practice good hygiene; wash thoroughly after handling. Do not wash dust laden clothing with other items. Comply with OSHA Std. 1910.132,133,134. IX. SPECIAL PRECAUTIONS Monitor to determine if Dust or Fiber is released above permissible time weighted averages. Clean storage areas of dusts by vacuuming. Use every precaution to keep airborne dusts to a minimum. NOTE: All data contained herein is based on information from raw material suppliers with cross checks against ACGIH data and OSHA TLV'a and is believed to be reliable. However, it is the user's responsibility to determine the safety of the product for his own use. Nuturn has no control on the actual use by others and cannot assume liability for the effects of such use. Governmental regulations or acquisition of additional information may necessitate revisions to any or all sections of this data sheet and such data will be supplied as it becomes available. User is also responsible for obtaining up-to-date information as appropriate. NA-3 VPD-158-0001040