Document 4QJR5rNOBdBN0znK5kRp2pzvR

( Engineering Material Specification ^MalarWNam*.. GASKET, ASBESTOS/STYRENE FIBER COMPOSITION 1,. SCOPE 8p*dfiortoiNumber E8W-MBG1D9-B * Hie material defined by this specification is An asbestos/styrene fiber gasket, which has been coated on both sides with a graphite compound and post cured to increase abrasion . resistance and improve bolt torque retention. S. APPLICATION This specification was released originally for material used as a gasket for the rear axle housing cover. 3. REQUIREMENTS Conditioning prior to testing shall be in conformance with ASTM F 104, Type 1, unless otherwise specified. 3.1 TENSILE STRENGTH, min (ASTM F 39, Tested perpendicular to the grain) 12S0 psi (8.6MPa) 3.2 COMPRESSIBILITY, min (ASTM F 36, Procedure "A") Recovery, min 18% 40% 3.3 IMMERSION IN LIQUIDS (ASTM D 471, 22 h at 23 2C) ASTM Oil No. 1 ASTM Oil No. 3 ASTM Fuel "A" i ASTM Fuel "Bn \ Water Weight Increase, max 46% 70% 35% 55% 50% 3.4 COMPRESSION SET, max ^ (ASTM D 395, Method "A", 22 h at 70 1C) 15% 3.5 SUPPLIER'S RESPONSIBILITY Material supplied to this specification must equivalent to that originally approved. Changes in formulation or processing shaEr^et be made without prior approval as described in Supplier Procedure I-A. ~ - - _ 4. APPROVAL OF SUPPLIERS Suppliers to this specification must be approved by the affected product engineering office. Procedure for gaining approval of a specific material to a new/existing ES-M specification is contained in Supplier Procedure 1-A. Approved new suppliers will be added to the Engineering Materials Approved Source List. bate 1975 ibcy 1965 01 11 52."w U | Revittona i t j Metricated, Renumbered & Retyped I Released Per PCR 406856 .. CWI0B-Rb-82Ulsi?fc^rWVwijuu_i. W PBe _Jl ol pool 1370