American Society of Heating and Ventilating Engineers Guide, 1926-27 wall coils, one pipe over the other; pipes pocketed under plant benches or in narrow walks against the sides of solid beds are less efficient than those ini the open, but greenhouse heating engineers must deal with averages and the co-efficient 2 has been found to be safe.

American Society of Heating and Ventilating Engineers Guide, 1926-27 TEMPERATURE AND HUMIDITY CONTROL Air washers require method of control of temperature to prevent freez ing by too low temperature and of overhumidification by too high temperatures of the air entering and'leaving the washer.

American Society of Heating-and Ventilating Engineers Guide, 1928 Oil Table 1.

of andAmerican Society Heating Ventilating Engineers Guide, 1929 \ are given in Table 5.

American Society of Heating and Ventilating Engineers Guide, 1929 Table 10-A.

American Society of Heating and Ventilating Engineers Guide, 1929 A study of the drawing of a typical back draft diverter will make it plain that a stoppage in the chimney will cause the combustion products to come out into the boiler room, but there will be no interference with the complete combustion of the gas.

American Society of Heating and Ventilating Engineers Guide, 1929 Table 1.

W: F.

Publications 232 Madison Ave.

CHC 000066 vwncvii ru vMSMiiiitjiuii aiiayiuu ouivhjw, u.u V W WASHINGTON IMAGING SERVICES, LLC rdyo cm< PETER R KURES, MD 13033 BEL-RED RD #230 BELLEVUE, WA 9800S RE: SMITH, DEANE DOB: 10/19/1927 SEX: M ACCT#: 72998 Exam Date: 2011-06-03 Exam Location: Bellevue Patient Phone: 425/765-6363 ACCESSION: MODALITY: EXAMINATION: 2146490 XRAY XRAY CHEST 2 VIEWS CHEST RADIOGRAPH TWO VIEW ' HISTORY: Cough technique: PA and lateral at 2:58 p.m.

Elevators and Plant Railways pole to move cars bv a locomotive is dangerous under any circumstances and is not recom mended Safe practices It is vital that transportation personnel--as well as all other employees --observe safe practices They can be guided by the very same safety rules observed by all large rail road systems (See Association of American Railroads, Safety Rules for various services ) When plant railway safety problems arise, help and suggestions can be sought from the safety men and operating officers of a plant's connecting railway line Safety meetings and other educational ac tivities should be used to inform plant per sonnel about railway hazards To include all the safe practices required for the safe operation of railway equipment would require a book in itself However, a few of the more important ones are included here 1 Stop and look both ways before crossing any track 2 Expect trains or cars to move at any time, on any track, in either direction 3 Step over rails when crossing tracks Never step, walk, or sit on any rail 4 Never go between moving cars (or cars that may move) for the purpose of adjust ing couplers or for any other purpose (The once common practice of kicking couplers to align them is particularly dangerous ) 5 Give a hand or lamp stop signal and re ceive an acknowledgment of the signal before going between standing engines or cars 6 To close a boxcar door, place one hand on the door handle and the other on the back end of the door 7 Step down from cars --do not jump 8 Never attempt to ride the leading foot board of an engine (This rule applies to all employees, including switchmen ) References American Society of Mechanical Engineers, 345 East 47th St, New York, N Y 10017 ASME Boiler and Pressure Vessel Code, Section III, "Boilers of Locomotives," and Section VIII, "Unfired Pressure Vessels " American Standards Institute, 1430 Broadway, New York, N Y 10018 American Standard Practice for the Inspection of Elevators (Inspectors' Manual), A17 2 Safety Standard for Elevators, Dumbwaiters, Escalators, and Moving Walks, A17 1 (Also published bv American Society of Mechanical Engineers ) Safety Standard for Manlifts, A90 1 Association of American Railroads, 59 East Van Buren Street, Chicago, 111 60605 Engineering Division (American Railwav Engineering Association) Manual of Recommended Practice Safets Section, American Railroads Bldg , 1920 L St N\V , Washington, D C 20036 Safety Rules Governing Maintenance of Equipment and Stores Employees Safety Rules Coverning Maintenance of Way and Structures Employees Safety Rules Governing the Care, Maintenance and Operation of Mechanized Material Handling Equipment Used in Railway Operations Safety Rules Governing Tram, Engine, and Other Transportation Employees Federal Railroad Administration, U S Dept of Transportation, Washington, D C 20590 Laws, Rules and Instructions for Inspection and Testing in Steam Locomotives and Tenders and Their Appurtenances National Bureau of Standards, U S Department of Commerce, Washington, D C 20234 Na tional Electrical Safety Code, NBS Handbook H30 Also adopted as AS1 Standard C2 608

REPORT NO . t4*OOSO DATE PRINTED 0 IY 2 B /B I ' "TYPE 4 B LA N K E T OROeRS M U LTI COMMODITY .OUTER CODE -- 6 t - _____ _____ PACE NO. 1924

A quarterly Meeting of the Board of Directors of the 3ond.j.oa B^ ead P, roducts Company was held at the office of the Coc- .jo, 25 Broadway, Mew York City, Tuesday, September 20th 1921, i clock P.

A D-iii (TniNunD) Tii'n'inup'iii jiiuiuji ELECTROCHEMICAL INDUSTRIES (FRUTARONV LTD.

FILE NAME: General Electric (GE) DATE: 1925-1929 DOC#: GE059 DOCUMENT DESCRIPTION: Inspection Report with Cover Letter from Harvard ' ** INDUSTRIAL T0X1CL0ST HARVARD UNIVERSITY SCHOOL OF PUBLIC HEALTH SE VAN DYKE STREET Boston, Massach u setts January 16 9&6.