Document 93zO8dmxkz8NJmrawLOZDV1Mq
Hoffman Specialty Co., Inc.
Specialties Hean^r
TYPICAL INSTALLATION HOFFMAN "CONTROLLED HEAT" EQUIPMENT
NOS. 20 AND 21 HOFFMAN THERMOSTATIC STEAM TRAPS
Pressure Range 0 to 100 lb. Without Change or Adjustment.
The Hoffman Steam Trap Body is of strong, rugged all bronze construction.
The diaphragms in the thermostat, the valve pins and valve seat are all made of. the
same non-corrosive alloy which has been successfully used
for diaphragms in Hoffman Valves for a number of years.
The alloy withstands high temperature steam, and repeated
action without softening or cracking. It also withstands the
scoring action of steam.
.
A strainer is built into the trap body permitting ready
removal for cleaning. All renewable parts are interchange
able, permitting replacement without adjustment of any sort.
The trap is built to give maximum service with minimum
attention and when repairs or cleaning are required the work
can be quickly done.
The Hoffman Steam Trap normally has a wide open vent port which is maintained until all air and condensation is relieved from the system, after which steam contact with the thermostat closes the port. No hand operated by passes are required to vent air from the system. The trap cannot air-bind or freeze.
Nos-HO and St Hoffman Thermostatic Steam Trap
The discharge capacity is dependent upon differences between, the temperature of condensation delivered to the trap and steam temperature, the greater the difference the larger the capacity of the trap. The following table gives continuous discharge capacities in pounds per hour.
NO. 20 TRAP
Pressure, lbs. per sq. in........... 10 30 50 70 90 too
to
Temperature Drop 20.'.
275 550 715 820 900 925 375
Temperature Drop 35............. 725 1075 1380 1675 1830 1860 950
No. 20 Trap haa Y in. pipe connections. % in. port. Weight .it, lb. No. 21 Trap has */, in. pipe connections, in. port. Weight 3% lb.
Write for Descriptive Circulars
824
NO. 21 TRAP 30 50 70 90
100
725 925 1085 1190 1225
1410 1860 2250 2490 2550
jfjfffman Specialty Co., Inc.
Specialties, Heating and Pumps
HOFFMAN-ECONOMY RETURN LINE VACUUM PUMPS
^.Yheiet type vacuum producer used in these pumps is one of the simplest and best
methods for exhausting air and vapors'. It has no moving parts and avoids close
A i rances so that loss of efficiency, due to wear, is reduced to a minimum. Pumps will
'vih die extremely hot water and are smooth and quiet in operation.
" '^All units, of 16,000 sq. ft. and over have horizontal split case pumps with enclosed,
V -hie; suction, bronze impellers. Units of 12,000 sq. ft. and under have vertically split
- 011
Table--Vacuum Pumps
volute pumps, with enclosed impeller, re movable bronze stand bearing and outboard
Water Cap.
G. P. M.
Air
Motor H. P.
Cap. C. F. M.
20. lb.
Press.
ball bearing. Operation is controlled by float switch and vacuum regulator.
All sizes furnished in Duplex Units. When returns
.3 7 9 13 18
22 26 35 60 90 140 210 350
- SjJJJjrpraSure 3V-0, 10 lbs.
1 3
,V4z*
3 4i
7 9
21 'h
12 3
15 5
21 5
34 m
50 10
102 15
130 25
All other standard
are below pump inletan auxiliary accumulator
tank will permit operation on
float control only. All units completely assembled and wired ready for installation.
pumps, 20 lbs.
K HOFFMAN-ECONOMY HORIZONTAL CONDENSATION PUMPS
? Horizontal Condensation Pumps are made in Styles ''--o to 20 lb. pressure--"B --"C" and "D" for 35 to
" 100 lb. pressure. All units have bronze fitted, enclosed 'impellers. Styles A-B and C have vertically split case-- Style D horizontal split case. Style A pumps have out board ball bearing and self-lubricating, renewable bronze stand bearing. Style B and C have double outboard bear ings, ring oiling at driving end and ball bearing at opposite . end, both readily renewable. Style D has double outboard ring oiling bearings, both easily renewable.
Float switch mechanism is positive with bronze float arm supported by two liberal bearings. All units are completely assembled and wired, ready for installation.
style"A"
Pump and Style No. Capacity Sq. Ft. D ir. C. I. Radiation Pump Cap. G.p.m. Motor ||
H .P .
Speed R.p.m. Pump and Style No. Capacity
SDql.r .FtC. I.
Radiation 1Disc. Press. | Lbs.Sq.ln.il
Motor H. P.
Speed R.p.m. Pump and Style No. Capacity
Sq. Ft. Dir. C. I. Radiation Motor H. P
Capacity Table---Condensation Pumps--60 .Cycle and Direct Current
*4Qs. .
U.
8-
d U
?
SI Qj
i* so
JM i * QJ 0.0
li
I0A
30A 31A 32A
' 60A 6IA 62A 64B 65B
65C 66B 66C 67B 67C 68C 69C
1.000
3,000 3.000 3.000
10 2
10 - 5 15 5 20 5
Vs 1.750 Vs 1.750 Vz J.750 Vs 1.750
6.000 6.000
6,000
6,000 6,000
10 12
1,750
15 . 12 '/z 1,750
20 12 Vs 1,750
30 12 1 1,750
40 12 1 Vz 1,750
6,000 6,000 6.000 6.000 6,000 6.000 6.000
40 50 50 60 60 75 100
i*12 3.500
12 1,750
12 2 3.500 12 3 1,750
12 3 3.500 12 3 3.500 12 5 3.500
I0OA iOlA
I02A I03B I04B 105B
105C I06B 106C 107B 107C 109C
151A 152A I53B I55B 155C 157B 157C 159C
10.000 10 20 Vs 1,750 200A
10.000 15 20 ,# 1,750 201A
10,000 20 20
1.750 202A
10.000 25 20
1.750 203B
10.000 30 20 1/z 1.750
10.000 40 20 1/2 1.750 205B
10.000
10.000 10.000
10,000
40 50 50
60
20 1/2 3,500 20 2 1,750 20 2 3,500 20 3 1,750
205C 207B
207C 209C
\10,000 60 20 3
10.000 100 20 5
15.000 15 30 15.000 20 30
3,500 3,500
1.750 1.750
300A 301A
302A 303A
15,000 25 30 1 1,750
15.000 40 30 2 15.000 40 30 2 15.000 60 30 3 15.000 60 30 3 15.000 100 30 5
1.750
3.500
1.750 3.500 3,500
304A
307C 308C 1 309B
20.000
20,000 20.000
20,000
10 15
20 25
20,000
20.000 20,000 20.000
20.000
40
40 60
60 100
30.000
30.000 30.000 30.000
10 15 20 25
30.000 30.000 30.000
30.000
30 60 75
100
40 Vz 1.750 40 J.750
40 I 1.750 40 Wz 1.750
40 2
40 2 40 3
40 3 40 5
1,750
3,500 1,750
3.500 3.500
53 Vz 1.750 53 Vs 1.750 53 1 1.750 53 IVz 1.750
53 2 * 1.75053 5 3.500
53 7Vi L750 53 10 1,750
Complete Tables and Specifications for Pumps up to 70,000 sq.ft, capacity. Given in Our General Catalogue
825