Document 81EKnDOkvRrOBg96xw8MJe3y

Centre Analytical Laboratories, Enc. 3048 Research Drive Phone: (814) 231-8032 State College, PA 16801 Fax: (814) 231-1253 or (814) 231-1580 Analytical Report Fluorochemical Characterization of Drinking Water Samples Columbus, GA (W2336) Centre Analytical Laboratory Report No. 023-007F Testing Laboratory Centre Analytical Laboratory, Inc. 3048 Research Drive State College, PA 16801 3M Environmental Laboratory Contact Kent R. Lindstrom Bldg. 2-3E-09 P.O. Box 33331 St. Paul, MN 55133-3331 Phone: (651)778-5352 Requester Kris J. Hansen, Ph.D. 3M Environmental Technology & Safety Services Bldg. 2-3E-09 P.O. Box 33331 St. Paul, MN 55133-3331 PAGE 1 0 F 5 000314 1 Introduction Results are reported for the analysis of a series of drinking water samples received by Centre Analytical Laboratories, Inc. (Centre) from the 3M Environmental Laboratory. The samples were collected from Columbus, GA. The Centre study number assigned to the project is 023-007. Specific fluorochemical characterization by liquid chromatography / tandem mass spectrometry (LC/MS/MS) was requested for all samples. A total of 16 samples were received for analysis. The samples were prepared and analyzed by LC/MS/MS for the following list of fluorochemicals: Table 1: Target Analysis Compound Name Perfluorooctane Sulfonate Perfluorooctane Sulfonvlamide Perfluorooctanoate Acronvm PFOS PFOSA POAA Data generated in support of this study was generated according to USEPA Good Laboratory Practices (GLPs). The analytical method used was validated by Centre. The validation protocol and results are on file with Centre. Data presented here is the highest quality data available at this time. 2 Sample Receipt The samples were submitted in individual plastic containers and were not preserved. Sixteen individual sample containers were received. Samples were received on 02/15/00. The sample collection dates were not supplied. Chain-of-custody information is presented in Attachment A. 3 Holding Times The analytical method used was validated against a maximum holding time of 14 days. The stability of the analytes of interest for longer periods has not been determined. PAGE 2 OF5 000315 4 Methods - Analytical and Preparatory 4.1 LC/MS/MS 4.1.1 Sample Preparation for LC/MS/MS Analysis Samples were initially treated with 200 uL of 250 mg/L sodium thiosulfate solution to remove residual chlorine. Solid phase extraction (SPE) was used to prepare the samples for LC/MS/MS analysis. A forty-milliliter portion of sample was transferred to a C18 SPE cartridge. The cartridge was first eluted with 5 mL of 40% methanol in water solution. The eluate was discarded and the SPE column was then eluted with 100% methanol. A 5 ml portion of methanol was collected for analysis by LC/MS/MS. This treatment resulted in an eight-fold concentration of the samples prior to analysis. 4.1.2 Sample Analysis by LC/MS/MS In HPLC, an aliquot of extract is injected and passed through a liquid-phase chromatographic column. Based on the affinity of the analyte for the stationary phase in the column relative to the liquid mobile phase, the analyte is retained for a characteristic amount of time. Following HPLC separation, ES/MS provides a rapid and accurate means for analyzing a wide range of organic compounds, including fluorochemicals. Electrospray is generally operated at relatively mild temperatures; molecules are ionized, fragmented, and detected. Ions characteristic of known fluorochemicals are observed and quantitated against standards. A Hewlett-Packard HP1100 HPLC system coupled to a Micromass Ultima MS/MS was used to analyze the sample extracts. Analysis was performed using selected reaction monitoring (SRM). Samples were extracted on 2/24/00 and analyzed by MS/MS between 2/26/00 and 2/27/00. The HPLC and MS/MS methods used for analysis and instrument parameters can be found in attachment D. 5 Analysis 5.1 Calibration A 7-point calibration curve was analyzed at the beginning and end of the analytical sequence for the compounds of interest. The calibration points were prepared at 0, 25, 50, 100, 250, 500, and 1000 ng/L (ppt) The response of the quantitation ion versus the concentration was plotted for each point. Using linear regression with 1/x weighting, the slope, y-intercept and correlation coefficient (r) and coefficient of determination (r2) were determined. A calibration curve is acceptable if r >0.985 (r2 > 0.970). Calibration standards are prepared using the same SPE procedure used for samples. Calibration check standards were analyzed periodically (every three to five sample injections) throughout the analysis sequence. Compliance is obtained if the standard analyte concentrations are within +/-20% of the actual value. For the results reported here, calibration criteria were met. PAGE 3 OF5 C00316 5.2 Blanks Extraction blanks were prepared and analyzed with every extraction batch of samples. The extraction blanks should not have any target analytes present at or above the concentration of the low-level calibration standard. For these samples, the extraction blanks were compliant. Instrument blanks in the form of clean methanol solvent were also analyzed after every highlevel calibration standard, and after known high-level samples. Again, the blanks should not have any target analytes present at or above the low-level calibration standard. For the samples presented here the instrument blanks are compliant. 5.3 Surrogates Surrogate spikes are not a component of the LC/MS/MS analytical method. 5.4 Matrix Spikes Matrix spikes were prepared for every sample at a concentration of 100 ng/L using all compounds of interest. Matrix spike recoveries are given in Attachment C. Field spikes were also prepared on several samples at a concentration of 100 ng/L using all compounds of interest. Field spike recoveries are also given in Attachment C. The field spike results for sample MC-529H gave recoveries for all compounds of approximately 1000 %, indicating that this sample was possibly spiked at 1000 ppt instead of 100 ppt. 5.5 Duplicates All samples were analyzed in duplicate. Results are given along with the sample results in Attachment B. 5.6 Laboratory Control Samples Milliq water was spiked with all compound of interest at 25 and 250 ng/L. All recoveries for all compounds were between 70-130% in each LCS. 5.7 Sample Related Comments Field blank samples consisted of empty containers. Forty milliliters of type I water filtered through a hypercart> cartridge was added to the empty container and analyzed in the same manner as the other samples. 6 Data Summary Please see Attachment B for a detailed listing of the analytical results. 7 Data/Sample Retention Samples are disposed of one month after the report is issued unless otherwise specified. All electronic data is archived on retrievable media and hard copy reports are stored in data folders maintained by Centre. PAGE4 OF5 000317 8 Attachments 8.1 Attachment A: Chain-of-Custody 8.2 Attachment B: Results. 8.3 Attachment C: Matrix Spike Recoveries (Field and Laboratory Spikes) 8.4 Attachment D: LC/MS/MS Raw Analytical Data 9 Signatures Kevin J Lloyd, Vice President Date Date Other Lab Members Contributing to Data Enaksha Wickremesinhe Karen Smith PAGESOF5 000318 B B B B B B B B B B II B il I I B B B Sample Condition Upon Receipt: 9 Acceptable O Other._____________________ Temperature:_______ |C___________ > Received on Ice_____________________________ Other Associated CoC: m i , O l X i , p U l , 1*7 1 1 .3 , n i2 S |C o p ie s ^ ^ _ fin n r M o 3SVI Envii .mental Laboratory Form 38778 -PW O Shipping Address: 3M Bldg. 2-3E-09 935 Bush Avenus S I Paul. MN 55106 Tslephons: Sam pls Receiving: (651) 778-4946 Alternate: (651) 776-6753 FAX: (651) 776-6176 a . Contact Name ,,3 .;" 8 Company js t f Y ) \4 a ^ V \ t : * Mailing Address f o u i l A i r i i S - T f - O I 0>. City. State. Zip S f . O t u l f b i r t S r / 3 3 a Telephone # *7*7Sf- /,, O f.fc Special Instructions snd/or Specific Regulatory Requirements: (method, limit of detection, reporting units, etc.) ( Z a j - q W Chain of Custody /Requev jr Laboratory Analytical 17131 Project ID/Project Name Q J A ^ c G '1 Template # ' Project Lead n Dept. # (main) ^40^ 1' 4 i u X jb s V W L r-s rs Firfll Report Due Date QT O. Internal Due Date Class/Job/Project # O O l O s ^ S C J O ^ Date Available 3M Env ) P roject# For Internal Use Only P W f, S S P 1 FAX * ( L & V l 1~1% ~ U l l l Date Due Contract Lab P re s e rv a tiv e s : c i Aj t L Analysis Requested: Complete below. Attach any associated Information. VOCs j Other Total Number of Containers C o u * n b i > j Cp A ozn X o* 3 X * C zo Item # Client Sample Identification 3M LIMS# Date Time Sampled Sampled Matrix/ Media Enter the number ot containers of each (Enter an X in the box below to indicate reouest) 1. v r * - .- ^ U -< > H i 2. m r - s a a M - O u ^ -P l-rF iV L L S p tfc i -P IA ? b jo m o J A / \A \ U J /d i* 3. r t ) t - s 3 f i - > V f c e i ~ U b S p V u t . - P | / 0 4. m i - S 5 i U - s , t t g a - P / / 0 ______________ A 5. m e 6. 8. 9. 10. Collected by (print): *o o3(3ft Item # b:Lg. *5 ,C : J. O - f \ a J _______________________ 6 \4 tn K -P / _i " --------------- -- mb. :<- Relinquished by/Affillation j 4 ___ \! V \/ J 0^ ____ J - 4Ni t -i Collector's signature: " Ifn m g l :j Date Shipped Via:, M nc / V- O f 7 \ 1 I \ l __ L_ Received bv/Affiliation Time Date Z-i-ct? Sample Condition Upon Receipt: # Acceptable 0 Other: Temperature: 'C Received on Ice Other Associated CoCs: \ T t l D , f j l-t| f l 1 1 1 , p )l m z 7 ,m z i/ p iz ^ n s o , n i3 3 t n ^ j Copies to. Comments: 1 C e n tre A n a ly tic a l Q V g w S S k , L a b o r a to r ie s , in c. 3048 Research Drive, State College PA 16801 814-231-8032 FAX 814-231-1253 Analytical Results W2336 Columbus, GA 3M Sample Identification MC-515H MC-517H MC-520H MC-521H MC-523H MC-526H MC-528H MC-531H NA MC-532H NA MC-533H Sample Description Intake-P/N Intake-P/N duplicate Intake-Field Blank Empty Outflow-P/N Outflow-P/N duplicate Site 1 P/N Site 1 P/N duplicate Site 2 P/N Site 2 P/N duplicate Site 3 P/N Site 3 P/N duplicate Field Blank-P/N Empty PFOS (ng/L) 61.2 53.3 <25 61.5 62.5 57.5 55.7 57.4 55.4 61.7 57.8 <25 PFOSA (ng/L) 11.7 J 10.5 J <25 14.9 J 14.9 J 14.9 J 11.3 J 12.6 J 13.1 J 14.8 J 11.5 J <25 J - Compound is. present, but below the reporting limit of 25 ng/L. The result is an estimated value. POAA (ng/L) 25.5 24.7 J <25 28.8 25.3 26.0 23.8 J 26.3 24.6 J 25.4 24.1 J <25 P lease re fe r to th e re ve rse s id e fo r o u r s ta n d a rd term s a n d c o n d itio n s . 0GG321